Filter
Top Products
6
Air Conditioner Features
(continued)
TO TURN UNIT ON: YOU WILL SEE:
NOTE: The following instructions represent the Unit Controls, the same
instructions can be used for the Remote Control.
DO THIS:
PRESS ON/
OFF
BUTTON
TO CHANGE TEMPERATURE
SETTING:
YOU WILL SEE:
TO ADJUST FAN SPEEDS: YOU WILL SEE:
DO THIS:
PRESS TO
RAISE
PRESS TO
LOWER
DO THIS:
PRESS TO
SELECT:
FASTER
SLOWER
A 2 Digit Display is used to indicate the Fan Speed setting,
from 10 through 99. When the “SLOWER” button is pressed
the motor speed will slow down at multiple intervals (90 distinct
settings), to a minimum setting of 10. To speed the motor up,
press the “FASTER” button. The speed will increase at multiple
intervals to a maximum setting of 99. After 5 seconds the control
will automatically change back to displaying the set temperature.
Note: Tap or hold either up(
) or down( ) button until the
desired temperature is seen on the display. This temperature
will be automatically maintained anywhere between 60˚F (16˚C)
and 90˚F (32˚C). If you want the display to read the actual
room temperature. See “To Operate on Fan Only” section on
Page 7.
SZ000400(En)-Yaokong 12/10/2004, 5:36 PM6