Filter
Top Products
6
Installation Instructions
2009 Electrolux Home Products, Inc. All rights reserved.
Installation Instructions
EXAUSTING HOT AIR
1. Take the hose out from back of the unit (Fig. 3).
2. Remove adaptor A from unit by sliding sideways (Fig. 4 ).
3. Extend either side of the hose (Fig. 5) and screw the hose to
adaptor A (Fig. 6) .
4. Extend the other side of the hose and screw it to adaptor B (Fig. 7).
5. Slide the assembly onto unit (Fig. 8).
6. Affix the adaptor B into the window slider kit and seal. (Fig. 9&10)
In the COOLING Mode the appliance must be placed close to a window or
opening so that the warm exhaust air can be ducted outside.
First position unit on a flat floor and make sure there’s a minimum of 12"
clearance around the unit, and is within the vicinity of a single circuit outlet
power source.
The hose can be extended from its original length of 15
" up to 55", but it is
the best to keep the length to minimum required. Also make sure that the
hose does not have any sharp bends or sags. (Fig. 11)
Fig. 9
Window Slider Kit
Minimum:26.6"(67.5cm)
Maxmum:48.5"(123cm)
Fig. 10
Window Slider Kit
Minimum:26.6"(67.5cm)
Maxmum:48.5"(123cm)
Fig. 11
Fig. 6
Take the hose out
Fig. 3
Fig. 4
Slide out
Fig. 8
Slide onto
Fig. 7
Fig. 5
Extend the side of hose
Vertical
window
Horizontal
window