Friedrich WY09 Air Conditioner User Manual


 
7
How to change airfl ow direction
The DISCHARGE GRILLE is installed at the factory to provide 45º
upward air
flow into the room. (Direction 1 in Figure 5). If a vertical
air
flow is desired (Direction 2), the direction can be changed by rotating
the DISCHARGE GRILLE.
Unplug the air conditioner.
Remove the DISCHARGE GRILLE RETAINER attached with one
screw in the right side of the grille.
Remove the DISCHARGE
GRILLE from the retaining slots near the
CONTROLS, and rotate the grille as shown in Figure 5.
Reinstall the DISCHARGE GRILLE by placing it in its retaining slots.
gniniater eht htiw RE NIAT ER ELLIRG EGRAHC SID eht hcattaeR
screw. The unit is now ready to operate.
How to cover inner weather panel holes
Two beige plugs are included in the plastic bag taped to the WallMaster
chassis. These plugs may be used to cover the two holes left after
removing the inner weather panel (see Figure 5). The plugs must be
attached before the DECORATIVE FRONT frame is installed.
Electrical requirements
IMPORTANT: Before you begin the actual installation of your air
.woleb noitamrofni eht dna sedoc lac irt cele lacol kcehc ,renoitidnoc
Your air conditioner must be connected to a power supply with the same
AC voltage and hertz rating as mar
ked on the nameplate located on
the chassis. Only alternating current (AC) can be used. Consult page
3 for the correct type of receptacle for your model.
An overloaded circuit will invariably cause malfunction or failure of an
lacirtcele eht taht tnat rop mi ylemertxe si ti ,erofereht ,renoitidnoc ria
power and the wiring is adequate. Consult your dealer or power
company if in doubt.
CIRCUIT PROTECTION - Before installing or relocat
ing your
Friedrich Room Air Conditioner, check the amp rating of the circuit
breaker or "TIME-DELAY" fuse. Refer to the nameplate located on
tiucric ro esuf tcerroc eht enim ret ed ot sissahc renoitidnoc ria eht
deecxe TON TSUM gnitar ehT .ledom ruoy rof ega rep ma rekaerb
the value stated on the nameplate. If the air conditioner is connected
to a circuit protected by a fuse, a "TIME-DELAY" fuse must be
used due to the momentary high current demands when your air
conditioner is started.
Return
Air Grille
Decorative
Front
WSD
Sleeve
7
6
5
3
C
6
54
321B
A
M
B
01
A
7
0SW
#LEDO
Airflow
Rotate
Discharge
Grille
Di
1/4”
ameter Plug
1
1
1
2
2
2
Figure 5
Electrical Shock Hazard
Use correct circuit protection.
Failure to follow these instructions can
result in death, fire, or electrical shock.
WARNING