Filter
Top Products
Service Manual 8
REMOTE CONTROL
POWER
To turn the air conditioner ON,push this button.
To turn the air conditioner OFF,push the button again.
This button takes priority over any other button.
Use this button to automatically control the
temperature of the room.
The tmeperature can be set within a range of
increments of 1 F.
The setting appears in the display.
60 F to 86 F by
TEMPERATURE SETTING
FAN SPEED
Every time you push this button,it advances the setting as follows:
Low[F1]} High[F2]
{High[F2]
TIMER
SHUT-OFF TIME
You will usually use shut-off time while you sleep.
If unit is running,use Timer to set number of hours until shut-off.
For your sleeping comfortonce Timer is setthe Temperature
setting will
and once again after another
30 min.
raise 2 F after 30 min
Push Timer button to advance setting from 1Hour→
2Hour →...
→12Hours maximum.
START TIME
If unit is off,use Timer to set number of hours before nuit starts.
Push Timer button to advance setting from 1Hour→
2Hour →...
→12Hours maximum.
MODE
Push this button to shift mode of operation from COOL → MONEY SAVER→ FAN ONLY→HEAT
COOL:
Fan runs continually for normal cooling operation.
MONEY SAVER:
The fan stops when the compressor stops cooling.Approximately every 3 minutes the fan will turn on and the nuit will
check the room air temperature to determine if cooling is needed.
FAN ONLY:
Fan-only operation.
HEAT:
Fan runs continually for normal heating operation.
CAUTION
When the air conditioner has been performed its
cooling or feating operation and is turned off or
set to the fan positionwait at 3 minutes
before resetting to the cooling operation again.
A slight heat odor may come from the nuit
when first switching to HEAT after the
cooling season is over.This odor,caused
by fine duct particles on the heater,will
disappear quickly.This is harmless.