Friedrich SS16 Air Conditioner User Manual


 
12
920-198-00
STONE LEDGE
" SLOPE
DOWN
STRAIGHTEN TAB TO LAY FLAT
ALONG THE BOTTOM RAIL OF
THE SHELL
SECURE THE LONGEST SIDE OF
THE BRACKET TO THE SHELL
ADJUST IN OR OUT TO REST
ON LEDGE
Figure 1A TYPICAL MOUNTING SCHEME
10 - 24 SCREW
10 - 24 FLAT NUT
" SLOPE
DOWN
" SLOPE DOWN
#12A x 2" SHEET METAL
SCREW
1" x 4" OR 2" x 4" SPACER
BE TWEEN WALL AND
BRACKET SHOULD BE
USED ON ALUMINUM,
ASBESTOS OR VINYL
SIDING.
DISCARD
SHADED AREA
CUT
HERE
CUT TO FIT DIMENSION "A"
AND BEND DOWN TO FORM A
VER TI CAL LEG.
STONE LEDGE
OUTSIDE WALL
DIMENSION "A"
SUPPLY AIR
RETURN AIR
CONDENSER
AIR INLETS
CONDENSER
AIR OUTLET
STONE LEDGE
" SLOPE
DOWN
#12 x 2" SHEET
METAL SCREW
2" x 4" SPACER
STEP 9 CUT WINGBOARD PANELS – Measure and cut the wingboard
panels from the Masonite sup plied (Item #8) to t the spaces be-
tween the side window channels and the sides of the cab i net. (See
Figure E).
NOTE: AFTER CUTTING THE PANELS, MAKE A TRIAL TEST TO SEE IF
THEY FIT THE SPACE WITH ABOUT
1
8
" CLEAR ANCE BEFORE
GOING TO STEP 10.
STEP 10 ASSEMBLE THE CLIPS TO THE WINGBOARD PANELS-
Assemble the "J" type speed nuts (Item 9) and spring steel clips
(Item 10) to the edges of the cut wingboard panels (See Figure F).
"J" TYPE SPEED NUT
(ITEM #9) 2 REQUIRED
SPRING STEEL
CLIP (ITEM #10) 2
RE QUIRED
CUT EDGE
SLIDE CLIP OVER
CUT EDGE OF
WINGBOARD
PANEL
CENTER THE HOLE IN THE
SPEED NUT OVER THE SLOT IN
THE WINGBOARD PANEL
CUT
WINGBOARD
PANEL
3"
3"
Figure F
Figure 3A TYPICAL MOUNTING SCHEME Figure 4A REVERSE SUPPORT BRACKET SCHEME
Figure 2A MODIFIED MOUNTING SCHEME