Friedrich SS14M10 Air Conditioner User Manual


 
When the user has completed setting start times and options (or at any
point in the process) they can press to toggle to the next day (or set of
days), or they can press and hold for 3 seconds to save their changes
and exit the set schedule mode. Once programmed you can SAVE and
EXIT or select another day group by pressing SCHEDULE.
If the user should decide they don’t want to use any or all four time
periods for the day, they can set any period to be pressing This will
blank out the options and display the word SKIP. This can be undone by
pressing again. The digital control defaults to the time period setting
inmediately prior to the user advancing to SKIP. to
continue on to the next time period. SKIP
continues the settings of the
previous time period, it will terminate at the
start of
the next time period
37
FRR038
FRR039
FRR040
If the system mode is set to AUTO (Heat-Cool Unit only), a 2nd temperature
labeled “Heat J Set Point” displays. Use (UP) or (DOWN) arrows
to increment/decrement the heat temperature. The other parameters
.neercs siht no degnahc eb tonnac )EDOM NAF ,DEEPS NAF ,METSYS(
The temperature range for AUTO mode must remain a minimum of 3
degrees apart at all times. If the high or low temperature is adjusted too
close to its counterpart, that temperature not being directly changed will
increase/decrease as needed to maintain the 3 degree spread. The user
presses
to advance to the next time period.
If the user selects FAN-Only mode, the word FAN displays for 2 seconds.
If the user wants the air conditioner to power down for a period of time,
pressing
hibernation until the next scheduled period. This feature is available during
FRR041
Press
,
continue
Set Schedule – Away, Return, Night Periods
FRR042
Each of the additional periods (Away, Return, Night) are programmed
identical to the programming for the Wake period. The appropriate
sequence.
NOTE: Day group sequence is as follows: Monday through Friday
(weekday), Saturday – Sunday (weekend), Monday through
Sunday (7-day), and individual days Mon JTue JWed JThru
J J J
FRR043
Schedule Mode Completed.
In this mode you may adjust the FAN SPEED. The FAN SPEED options
are: LOW, MED, HIGH or MAX*. Fan speed depends on your unit's
model. The MAX* Setting is available on all SS and SM models.
Once the user has programmed all four (4) time periods, the program goes
to the next day or day group by pressing SCHEDULE. For example, if
individual days are being programmed, the program will go from Mon to
Tues leading the user through 4 periods for Tues until it reaches the end of
the week.
Note that by pressing SCHEDULE repeatedly the process follows a
continuous loop until the user decides to exit.
P is not selected.where SKI