Filter
Top Products
8
2 DIGIT DISPLAY
Shows Setting for:
- Set Point (Temperature)
- Room Temperature
- Clock (AM/PM)
ON / OFF:
Turns unit on/off
SYSTEM:
Cycles between
HEAT, COOL or
FAN ONLY
FAN MODE:
Sets fan to either:
- Cycle automatically
- Run continuously
FAN SPEED:
Sets fan speed:
LOW, MED, HIGH
or AUTO
(as equipped)
HEAT
FILTER
Check / Clean
AUTO SPEED
Automatically selects
best fan cooling or heating speed
SMART OPERATING
(see page 10)
FAN SPEED
Selected fan speed
ROOM TEMP
SET POINT
AM
PM
F
AUTO FAN
CONTINUOUS
AUTO SPEED
88
C
ON OFF
SCHEDULE
CHECK $MART
FILTER
COOL
FAN
ONLY
CONTROL
LOCKED
WI-FI
OPERATING (if equipped)
WAIT
COMPRESSOR
3 MINUTES
TIME DELAY
TEMPERATURE:
Increment UP
TEMPERATURE:
Increment DOWN
SCHEDULE ON
TIMER / SCHEDULE
Turns ON or OFF
TIMER ON
IR WINDOW:
Do not block
Let’s check out how to control your air conditioner. On the control panel, just above the POWER , is a liquid crystal display (LCD). All of the control panel function
buttons and mode icons can be viewed in Figure 6.
Power On – Press the button to turn on the air conditioner. The power button illuminates to indicate that the power is on. The backlight on the power switch
will automatically dim to 20% intensity after 15 seconds of inactivity. The remote contr
ol
can also be used to turn power ON / OFF (See Remote Control).
Display – The display is a high ef¿ ciency LCD with a built-in white backlight. The backlight has an automatic two (2) step dim function. After 15 seconds of
inactivity, the display dims to 20% intensity. After an additional 120 seconds, the display switches off. Touching any button automatically changes the display
to full brightness.
There are three control push buttons on each side of the display.
Kuhl Q Control Panel Operation
Figure 2