30
Final Inspection & Start-up Checklist
Inspect and ensure that all components and accessories have been
installed properly and that they have not been damaged during the
installation progress.
&KHFNWKHFRQGHQVDWHZDWHUGUDLQVWRHQVXUHWKDWWKH\DUHDGHTXDWH
for the removal of condensate water, and that they meet the approval
of the end user.
Ensure that all installation instructions concerning clearances around
WKHXQLWKDYHEHHQDGKHUHGWR&KHFNWRHQVXUHWKDWWKHXQLWDLU¿OWHU
indoor coil, and outdoor coil are free from any obstructions.
Ensure that the circuit breaker(s) or fuse(s) and supply circuit wire
VL]HKDYHEHHQVL]HGFRUUHFWO\,IWKHXQLWZDVVXSSOLHGZLWKDSRZHU
supply cord, insure that it is stored properly.
Ensure that the entire installation is in compliance with all applicable
QDWLRQDODQGORFDOFRGHVDQGRUGLQDQFHVKDYLQJMXULVGLFWLRQ
Secure components and accessories, such as a decorative front
cover.
Start the unit and check for proper operation of all components in
each mode of operation.
Instruct the owner or operator of the units operation, and the
PDQXIDFWXUHUV5RXWLQH0DLQWHQDQFH
NOTE: $ORJIRUUHFRUGLQJWKHGDWHVRIPDLQWHQDQFHDQGRUVHUYLFHLV
recommended.
Present the owner or operator of the equipment with the Installation
2SHUDWLRQ0DQXDODOODFFHVVRU\LQVWDOODWLRQLQVWUXFWLRQVDQGWKH
QDPHDGGUHVVDQGWHOHSKRQHQXPEHURIWKH$XWKRUL]HG)ULHGULFK
:DUUDQW\6HUYLFH&RPSDQ\LQWKHDUHDIRUIXWXUHUHIHUHQFHLI
necessary.
This is a warm weather appliance
<RXUDLUFRQGLWLRQHULVGHVLJQHGWRFRROLQZDUPZHDWKHUZKHQWKHRXWVLGH
WHPSHUDWXUHLVDERYH)&DQGEHORZ)&VRLWZRQW
cool a room if it is already cool outside.
Condensation is normal
$LUFRQGLWLRQHUVDFWXDOO\SXPSWKHKHDWDQGKXPLGLW\IURP\RXUURRPWRWKH
outside. Humidity becomes water, and your air conditioner will use most
RIWKHZDWHUWRNHHSWKHRXWVLGHFRLOFRRO,IWKHUHLVH[FHVVLYHKXPLGLW\
WKHUHPD\EHH[FHVVZDWHUWKDWZLOOGULSRXWVLGH7KLVLVQRUPDORSHUDWLRQ
Frosting
7KLVXVXDOO\RFFXUVEHFDXVHRILQVXI¿FLHQWDLUÀRZDFURVVWKHFRLOVDGLUW\
¿OWHUFRROGDPSZHDWKHURUDOORIWKHVH6HWWKH6<67(0PRGHWR)$1
21/<
and the frost will disappear. Setting the thermostat a little warmer
will probably prevent the frosting from recurring.
Noises
$OODLUFRQGLWLRQHUVPDNHVRPHQRLVH)ULHGULFKXQLWVDUHGHVLJQHGWR
RSHUDWHDVTXLHWO\DVSRVVLEOH$QDLUFRQGLWLRQHUPRXQWHGLQDZDOOLVTXLHWHU
than one mounted in a window. It is important to ensure that the chassis
seal gasket (Item 14) is properly installed (refer to installation instructions).