Filter
Top Products
En-4
Fig. 4 Remote Control Unit
C SLEEP button
D MASTER CONTROL button
E SET TEMP./SET TIME buttons (
)
F Signal Transmitter
G TIMER button
H FAN CONTROL button
I START/STOP button
J AIR FLOW DIRECTION
VERTICAL SET button
K AIR FLOW DIRECTION
VERTICAL SWING button
L AIR FLOW DIRECTION
HORIZONTAL SET button
M AIR FLOW DIRECTION
HORIZONTAL SWING button
N TIME ADJUST button
O ACL button
Rear side (Fig. 5)
P TEST RUN
● Touch the two metal contacts with a me-
tallic object to send the signal to perform
a test run.
● Perform a test run only when installing the
air conditioner. If the signal to perform a
test run is received during normal opera-
tion, the air conditioner’s thermostat will
malfunction.
● If the signal to perform a test run is re-
ceived during normal operation, the unit
will switch to the test operation mode and
the indoor unit’s OPERATION and TIMER
indicator lamps will flash simultaneously.
● To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
Q Remote Control Unit Display (Fig. 6)
R Transmit Indicator
S Clock Display
T Operating Mode Display
U Timer Mode Display
V Fan Speed Display
W Temperature Set Display
X Timer Set Indicator
Y Temperature Set Indicator
Fig. 1 Indoor Unit
1 Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
3 Remote Control Signal Receiver
4 OPERATION Indicator Lamp (red)
5 TIMER Indicator Lamp (green)
6 SWING Indicator Lamp (orange)
(VERTICAL SWING)
7 SWING Indicator Lamp (orange)
(HORIZONTAL SWING)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See page 16 Auto Restart).
8 Intake Grille (Fig. 3)
9 Air Filter
0 UP/DOWN Air Direction Flaps
A RIGHT/LEFT Air Direction Louvers
(behind UP/DOWN Air Direction Flaps)
B Drain Hose
9359944065_OM_en.p65 13/1/06, 14:144