Filter
Top Products
www.desatech.com
119360-01B
3
Figure 7 - Assembling Trim
ASSEMBLING TRIM
1. Remove packaging from three pieces of trim.
2. Locate two adjusting plates with set screws, and two
shims in the hardware packet.
3. Align shim under adjusting plate as shown in Figure 7.
4. Slide one end of adjusting plate/shim in slot on mitered
edge of top trim (see Figure 7).
5. Slide other end of adjusting plate/shim in slot on mitered
edge of side trim (see Figure 7).
6. While rmly holding edges of trim together, tighten both
set screws on the adjusting plate with slotted screw-
driver.
7. Repeat steps 2 through 6 for other corner.
Side Trim
Slot
Top Trim
Mitered Edge
Shim
Set Screws
Adjusting
Plate
Slot
FIREPLACE INSTALLATION
1. Fireplace should be fully assembled. See Assembling
Fireplace in replace owner’s manual.
2. Place mantel base close to installation location. See re-
place owner’s manual for installation clearances. Leave
enough room to get behind mantel once replace and
mantel assembly have been attached to base if installing
a replace with ange.
3. Install gas line. See Connecting to Gas Supply in replace
owner’s manual. Remember to leave access to the gas
shutoff valve somewhere on the base or where it is ac-
cessible to the user.
4. Check for leaks. See Checking Gas Connections in re-
place owner’s manual.
IMPORTANT: If your replace has a nailing ange see Installing
Fireplace with Flange. If your replace does not have a nailing
ange see Installing Fireplace without Flange, page 4.
Installing Fireplace with Flange
1. Place mantel assembly on wood base and center left to
right having back of assembly ush with back of base.
Mark placement on base along inside front of mantel
assembly. Remove mantel assembly from base.
2. Position replace on base centering left to right between
markings. Carefully position gas lines. IMPORTANT: Use
caution when positioning replace on base as base may
scratch.
3. With assistance, carefully place mantel over replace
(see Figure 8). Fireplace nailing anges will be to inside
of mantel. Align mantel with markings made previously.
Make sure back of mantel is ush with back of mantel
base. Adjust replace as necessary.
Figure 8 - Installing Fireplace with Flange
Assembled
Trim
(Side view
for clarity)
Mantel
Base
Shoulder
Screws
Figure 9 - Installing Brackets to Mantel Base
1
1
/
4
" Screw
Bracket with 1/2"
or 3/4" Screw
Gas Line
Access Hole
Possible
Shutoff Valve
Locations
4. Attach mantel to base using 1
1
/
4
" screws through pocket
holes. Using brackets and 1/2" or 3/4" screws from
bracket hardware kit, attach brackets to base and mantel
assembly using one bracket at each back corner of leg
sides and one on each leg front (see Figure 9).
5. Adjust replace so that it ts into mantel opening properly.
Shoulder
Screw