FMI (V)DVF42PS Indoor Fireplace User Manual


 
www.fmiproducts.com
125078-01B24
INSPECTING BURNERS
Pilot
Burner
Ignitor/
Sensor
Figure 35 - Correct Pilot Flame Pattern
Sensing
Rod
Check pilot ame pattern and burner ame
patterns often.
pILOT ASSEMBLY
The pilot assembly is factory preset for the
proper ame. Alterations may have occurred
during shipping and handling. The pilot is
located on right hand side of burner.
The ame must envelope 1/4" of top of the
ignitor/sensor and grounding stem.
If your pilot assembly does not meet these
requirements:
Turn the adjustment screw marked PILOT
clockwise to decrease or counterclockwise
to increase the ame to proper size (see
Figure 33, page 23). Do not remove the
adjustment screw.
see Troubleshooting, page 26
BURNER FLAME pATTERN
Burner ames will be steady, not lifting or oat-
ing. Flame patterns will be different from unit
to unit and will vary depending on installation
type and weather conditions.
If the vent conguration is installed incorrectly,
ames will lift or "ghost". This can be danger-
ous. Inspect ames after installation to ensure
proper installation and performance.
Figure 36 shows a typical ame pattern.
If burner ame pattern differs from that de-
scribed:
turn replace off (see To Turn Off Gas to
Appliance, page 23)
see Troubleshooting, page 26
Figure 36 - Typical Flame Pattern
CLEANING AND MAINTENANCE
WARNING: Turn off replace
and let cool before cleaning.
CAUTION: You must keep
control areas, burners and
circulating air passageways of
replace clean. Inspect these
areas of replace before each
use. Have replace inspected
yearly by a qualied service
person. Fireplace may need
more frequent cleaning due to
excessive lint from carpeting,
bedding material, pet hair, etc.
GLASS DOORS
WARNING: Handle glass
door panels with care. Do not
strike, slam or otherwise abuse
glass. Do not operate replace
with the glass door unlatched,
removed, cracked or broken.
WARNING: Do not use
abrasive cleaners as this may
damage glass. Use a nonabra-
sive household glass cleaner to
clean glass. Do not clean glass
when hot.