Filter
Top Products
Greenfi re Pellet Stove and Insert Owner's Manual
12
MAINTENANCE
EXHAUST PASSAGES
(season)
Removal of the firebox backing for bi-annual cleaning (refer to
Figure 12):
a) Open the door by lifting the handle, remove the burn pot and burn pot
liner.
b) Before trying to remove screws, lubricate all screws with penetrating
oil. ie. WD-40.
c) Loosen (do not remove) the four (4) screws that hold the brick liner
retainers in place. Remove side brick liners by sliding them from
under the screwheads.
d) Pull the center panel out. Ensure not to damage the 1" insulation
attached to the back of the center panel.
e) Vacuum and clean thoroughly.
Installation of firebox backing:
a) Return center panel to its original position.
b) Place the two (2) side panels back into the firebox, secure the two
(2) retainers and lock down by tightening the two (2) screws on each
side.
c) Replace the burn pot and burn pot liner.
d) Close the glass door and secure.
POST SEASON CLEAN-UP
Once you are fi nished using the pellet appliance for the season, unplug
the stove for added electrical protection. It is very important that the stove
be cleaned and serviced as stated above. Also remove any remaining fuel
from the hopper and auger.
CLEANING PLATED SURFACES
Painted surfaces should be wiped with a damp cloth periodically.
It is important to note that fi ngerprints and other marks can leave a per-
manent stain on plated fi nishes. To avoid this, give the surface a quick
wipe with denatured alcohol on a soft cloth BEFORE lighting the fi replace.
Never clean surfaces when they are hot. Do not use other cleaners or
abrasives as they may leave a residue or scratches, which can become
permanently etched into the surface.
FIREBOX PANEL
The paint on the steel fi rebox panels may peel. This is due to extreme
conditions applied to the paint and is not covered under warranty.
REPLACING DOOR GLASS
It is recommended that your Greenfire dealer replace the glass if
broken.
The door glass is made of high temperature PYRO CERAMIC 5 mm thick.
The center panel is 15.4” x 9.0” (39.0 cm x 22.9 cm) and side panels are
2.6 x 9.0 inches (6.7 cm x 22.9 cm). They must be replaced with (Part #
GF55-028 & GF55-029). Substitute materials will not be permitted.
MAINTENANCE
Figure 12: Firebox Components Removal.