Filter
Top Products
Fails To Operate
1. Is the power turned on?
2. Is the Blow Tube, Impeller Guard, Suction Tube or
Debris bag fitted correctly?
3. Check the fuse in the plug, if blown replace.
4. Fuse continues to blow?
Immediately disconnect from the mains electricity supply
and consult your local Approved Service Centre
Poor Blowing
1. The air inlets may be blocked, clean all air inlets.
2. Blow outlet may be blocked. Remove Blow Tube and
clear blockage with blunt edge instrument
3. If poor blowing persists?
Immediately disconnect from the mains electricity supply
and consult your local Approved Service Centre
Poor Vacuum
1.The air inlets may be blocked, clean all air inlets.
2. The Debris Bag inlet may be blocked. Remove
Debris Bag and clear blockage with a blunt edge
instrument.
3. If poor vacuuming persists?
Immediately disconnect from the mains electricity supply
and consult your local Approved Service Centre
Excessive Vibration
1. Inspect the fan for damage and replace if
necessary
2. If excessive vibration persists?
Immediately disconnect from the mains electricity supply
and consult your local Approved Service Centre
Fault Finding Hints
Q1
Emptying the Debris Bag
1. Remove the Debris Bag as described in
the ‘Converting from Vacuum to Blower
use’ section.
2. Empty debris bag as shown in Pic. Q1
D
O
N
OT
P
LACE
H
ANDS
IN
B
AG
W
HEN
E
MPTY
-
ING, SHARP DEBRIS CAN CAUSE INJURY (Q2)
3. Re-fit the Debris Bag as described in the
‘Vacuum Assembly’ section.
Emptying the Debris Bag
WARNING Never use water for cleaning your
product, use only a dry cloth. Do not clean with
chemicals or solvents, some can destroy critical
plastic parts.
After Using Your Product
1. Switch off and disconnect from the mains
electricity supply before cleaning your product.
2. Always empty the debris bag.(R1)
3. Inspect the fan for damage and replace if
necessary. Clean the fan with a soft brush
ensuring it is free from debris (S1)
4. Clean the Debris/Blow Outlet with a soft
brush.(S2)
5. Clean the air vents with a soft brush (S3)
6. Wipe over the product with at dry cloth (S4).
Storing Your Product
Always store the product in a dry place ensuring the
cable is not likely to be damaged on sharp edges etc.
S1
S2
S4
Caring for your product
S3
Q2
If any part is found to be defective due to faulty manufacture
within the guarantee period, Husqvarna UK Ltd, through its
Authorised Service Repairers will effect the repair or
replacement to the customer free of charge providing:
(a)The fault is reported directly to the Authorised Repairer.
(b)Proof of purchase is provided.
(c)The fault is not caused by misuse, neglect or faulty
adjustment by the user.
(d)The failure has not occurred through fair wear and tear.
(e)The machine has not been serviced or repaired,
taken apart or tampered with by any person not
authorised by Husqvarna UK Ltd.
(f) The machine has not been used for hire.
(g)The machine is owned by the original purchaser.
(h)The machine has not been used commercially.
* This guarantee is additional to, and in no way
diminishes the customers statutory rights.
Failures due to the following are not covered,
therefore it is important that you read the instructions
contained in this Operator's Manual and understand
how to operate and maintain your machine:
Failures not covered by guarantee
* Failures as a result of not reporting an initial fault.
* Failures as a result of sudden impact.
* Failures as a result of not using the product in
accordance with the instructions and
recommendations contained in this Operator's
Manual.
* Machines used for hire are not covered by this
guarantee.
* The following items listed are considered as
wearing parts and their life is dependent on regular
maintenance and are, therefore not normally
subject to a valid warranty claim: Electric Mains
cable, Debris Bag.
* Caution!
Husqvarna UK Ltd does not accept liability under
the warranty for defects caused in whole or part,
directly or indirectly by the fitting of replacement
parts or additional parts that are not either
manufactured or approved by Husqvarna UK Ltd, or
by the machine having been modified in any way
Guarantee & Guarantee Policy