Filter
Top Products
1. Form a loop in the mains cable (J1).
2. Push the loop through the slot (J2).
3. To secure, position the loop over the hook (J3).
4. Pull the cable back through the slot (J4).
J1
J2
Cable Restraint
J3 J4
WARNING
The use of eye protection is recommended. The use
of ear protection is recommended. To prevent dust ir-
ritation, the wearing of a face-mask is recommended.
Never point your product at bystanders.
Using As A Blower
Blow Mode - The product will blow debris from pa-
tios, paths, driveways, lawns, bushes, borders etc.
1. Point nozzle towards the ground.
2. To start press the switch to on (K).
3. Stand back from debris to be cleared.
4. Point the tube towards the debris and
slowly approach (L).
6. To stop press the switch to off.
• If Blow performance is reduced, the blow outlet
may be blocked. Switch off the product and dis-
connect from the mains electricity supply. Re-
move the Blow Tube and clear any blockage in
the blow outlet using a blunt implement (M)
Using As A Vacuum
Vacuum Mode - In this position your product will
pick up leaves, small twigs and garden debris.
1. Position the tube slightly above the debris,
press the switch to on (K)and move the
product slowly back and forth (N).
3. Do not force the tube into the debris as
this will impair performance.
4. To stop press the switch to off.
• If Vacuum performance is reduced, the
Debis Bag Adaptor may be blocked. Switch
off the product and disconnect from the
mains electricity supply. Remove the Debris
Bag and clear any blockage in the Debris
Bag Adaptor using a blunt implement (P)
K
L
P
N
M
How to Use