Filter
Top Products
Ti20
Users Manual
2-4
Table 2-1. Contents of the Home Display (cont.)
Number
Zone
Displayed
Information
Description
Temperature
Scale
Displays the target temperature, lower alarm limit (blue
upside triangle), high alarm limit (red upside down
triangle), temperature range bar, and temperature
color bar.
Emissivity
Setting
Display setting preceded by a 1 or 0 and followed by
two places after the decimal point.
RTC Setting
Reflected temperature compensation setting if RTC is
turned on. No decimal places.
Memory Location
Displays current memory location and total memory
locations available. For example, if the display shows
“Memory 16/32” this indicates that you are at memory
location 16 and there are 32 memory locations with
stored images.
Memory Location
Description
The default description is the number of the current
memory location. You can create a text description
using InsideIR and upload that location description
and image into the Imager. Memory location
description is limited to 30 characters.
Notes
Notes about the memory location created using
InsideIR. There is no limit to the number of characters
you can enter with the software but the Imager will
only display the first 30 characters.
C Information
Status Comments
or Selection
Options
This varies by screen and operation, Examples
include:
• Overwrite memory location 25?
• Delete image?
• Delete ALL images?
• ON or OFF for backlight adjustment
• °C or °F for temperature scale
Aiming and Activating the Laser
The laser is a sighting aid and is not required to take measurements. The laser is not
coaxial with the infrared channel, and the laser dot is offset from the center of the thermal
image (the crosshatch at the center of the display). The laser dot is not visible in the
thermal image.
W Warning
* To avoid eye damage, do not point laser at eye directly or
indirectly off reflective surfaces.
1. Press for G 2 seconds to turn on the Imager. The date appears in the upper right-
hand portion of the display.
2. Press F to turn the laser on and off. The laser warning symbol (J)appears in
the Header zone of the display when the laser is turned on.