Filter
Top Products
OPTIONAL LOCKING FEA
TURES
The locking featur
es are designed to discourage unauthorized removal of the battery or Alarm. It is not necessary to activate the locks in single-family
households where unauthorized battery or Alarm removal is not a concern.
These Smoke Alarms have two separate locking featur
es: one to lock the battery compartment, and the other to lock the Smoke Alarm
to the mounting bracket. Y
ou can choose to use either feature independently, or use them both.
Tools you will need: • Needle-nose pliers • Standard Flathead screwdriver.
Both locking featur
es use locking pins, which are molded into the mounting bracket. Using needle-nose pliers, remove one or both pins
fr
om the mounting bracket, depending on how many locking features you want to use.
T
o permanently remove either lock, insert a flathead screwdriver between the locking pin and the lock, and pry the pin out of the lock.
TO LOCK THE BATTERY COMPARTMENT
Do not lock the batter
y compartment until you have installed the
batter
y and tested the battery back-up.
1.
Push and hold Test/Silence button until the alarm sounds:
3 beeps, pause, 3 beeps, pause.
If the unit does not alar
m during testing, DO NOT lock the battery
compartment! Install a new battery and test again. If the Smoke
Alar
m still does not alarm, replace it immediately.
2. Using needle-nose pliers, detach one locking pin from the mounting
bracket.
3. Push the locking pin through the hole near the battery drawer on the
back of the Smoke Alarm.
TO UNLOCK THE BATTERY COMPARTMENT
Once the Smoke Alarm is installed, you must disconnect it fr
om the AC power
befor
e unlocking the battery compartment.
ELECTRICAL SHOCK HAZARD. T
urn off the power to the area where the
Smoke Alar
m is installed before removing it from the mounting bracket.
Failure to turn off the power first may result in serious electrical shock,
injur
y or death.
Always discharge the branch circuit before servicing an AC or AC/DC
Smoke Alarm. First, turn off the AC power at the circuit breaker or fuse box.
Next, r
emove the battery from Smoke Alarms with battery back-up. Finally,
pr
ess and hold the T
est/Silence button for 5-10 seconds to discharge the
branch circuit.
1.
Remove the Smoke Alarm from the mounting
bracket. If the unit is locked to the bracket, see
the section “To Unlock the Mounting Bracket.”
2. Disconnect the power connector by gently prying
it away fr
om the back of the Smoke Alarm.
3. Insert a flathead screwdriver under the head
of the locking pin, and gently pry it out of the
battery compartment lock. (If you plan to r
elock
the battery compartment, save the locking pin.)
4. To relock the battery compartment, close the
battery door and reinsert locking pin in lock.
5. Reconnect the power connector to the back of the Smoke Alarm, reattach
the Smoke Alarm to the mounting bracket, and restore the power.
When replacing the battery, always test the Smoke Alarm before relocking the
battery compartment.
TO UNLOCK THE MOUNTING BRACKET
ELECTRICAL SHOCK HAZARD. Turn off the power to the area where the
Smoke Alarm is installed before removing it from the mounting bracket.
Failure to turn off the power first may result in serious electrical shock,
injury or death.
Always discharge the branch cir
cuit before servicing an AC or AC/DC
Smoke Alarm. First, turn off the AC power at the circuit breaker or fuse
box. Next, remove the battery from Smoke Alarms with battery back-up.
Finally, press and hold the Test/Silence button for 5-10 seconds to
discharge the branch circuit.
1. Insert a flathead screwdriver between the
mounting bracket pin and the mounting bracket.
2.
Pry the Smoke Alarm away from the bracket by
turning both the screwdriver and the Smoke
Alarm counter
clockwise (left) at the same time.
TO LOCK THE MOUNTING BRACKET
1. Using needle-nose pliers, detach one locking pin from mounting bracket.
2.
Insert the locking pin into the lock located
opposite from the battery drawer as shown
in the diagram.
3. When you attach the Smoke Alarm to the mounting bracket, the locking
pin’s head will fit into a notch on the bracket.
4