Filter
Top Products
– 15 –
$UPLQJWKH6\VWHP
$UPLQJ&RPPDQGV
Before arming, close all perimeter doors and windows and make sure the Ready to Arm
message is displayed.
Mode Press these keys… Keypad Confirms By…
Stay security code + [3] (STAY)
• three beeps
• armed STAY message displayed
• red ARMED indicator lights
Night-Stay security code + [3] + [3]
• three beeps
• NIGHT-STAY message displayed
• red ARMED indicator lights
Instant security code + [7] (INSTANT)
• three beeps
• armed STAY message displayed
• red ARMED indicator lights
Note that entry delay is turned off.
Away security code + [2] (AWAY)
• two beeps, or, if programmed, beeping for
duration of exit delay
• armed AWAY message displayed
• red ARMED indicator lights
Leave the premises through an entry/exit
door during the exit delay period to avoid
causing an alarm. The keypad beeps rapidly
during the last 5 seconds of the exit delay to
warn you that it is ending.
Maximum security code + [4] (MAXIMUM)
• same as Away (described above)
Note that entry delay is turned off.
Quick Arming
If "Quick Arming" was programmed by the installer, the
[#]
key can be pressed in
place of the security code when arming the system. However,
the security code
must always be used to disarm the system.
Function Key Arming
For any arming command, a function key may have also been programmed for your
system. If so, you can press and hold the appropriate function key for 2 seconds to arm
the system. See your installer for the designated functions (see
Single Button
Arming
section).
Refer to the
Accessing Other Partitions
section for information on multi-partiion
arming (FA168C).