Filter
Top Products
Setting Up Your DWB-700 Family Camera
Model DWB-700 User's Manual
8
To Wall or Ceiling Mount
Use stand to mark position of screws. Before drilling a hole, it is important to check
the reception and camera/monitor positioning in the place that you intend on hanging
it to the wall or ceiling.
1 Select the position for the camera and secure the camera stand.
a. Pre-drill holes using a 7/32 inch drill bit.
b. Insert wall anchors and gently tap with hammer
until the anchors are flush with the wall.
c. Secure stand with screws.
2 Screw the camera onto the bracket.
3 Adjust camera to the proper view angle. Make sure the lens is upright relative to
your subject. Tighten the nut. Adjust the antenna to an upright position.
PAIRING (USING THE DWB-740 FAMILY MONITOR)
Access the Pairing menu from the Main Menu. Use this menu to pair receiver with camera.
1. Use
to select a channel.
2. Press
to start system countdown from 60 seconds.
3. Within 60-second countdown, press PAIR at the camera side. Image will
display when pairing is complete