Filter
Top Products
Setting Up Your DWB-700 Family Camera
Model DWB-700 User's Manual
7
Setting Up Your
DWB-700 Fa m ily Ca m e ra
GENERAL P RECAUTIONS
Do not place any of the equipment near a radiator, vent, or other place
where it might be exposed to heat, moisture, dust, vibrations, or strong
magnetic fields. If any liquid comes into contact with the monitor, turn off the
power immediately and have a qualified technician inspect the equipment
before using it again.
When installing the camera, follow manufacturer’s advice when using power
tools, steps, ladders, etc. and wear suitable protective equipment (e.g.,
safety goggles) when drilling holes. Before drilling holes through a ceiling,
check for hidden electricity cables and water pipes.
INSTALLING THE CAMERA
Before the camera is installed, the camera pairing procedure
should be completed.
DC Power Supply Mode
1 Connect the power cable to the DC IN of the camera.
2 Plug the power supply into the electrical outlet.
3 Press POWER button to turn on the camera.
Battery Power Supply Mode
1 Insert 3 AAA alkaline batteries making sure the
polarity is correct.
2 Press POWER button to turn on the camera.
Table top or wall mounting:
Determine a location for the camera that will provide the best view of your baby in his
crib. Place the camera on a flat surface, such as a dresser, bureau, or shelf. Or
mount the camera on a wall. Be sure to place camera and monitor no less than 3 feet
away from your baby’s crib. Do not place the camera near open windows, direct
sunlight or heat sources.