Filter
Top Products
14
1
1
REPLACEMENT INSTRUCTIONS
REMOVING THE BOTTOM PLATE
Set the vacuum cleaner to the
parallel position and turn it over.
REATTACHING THE BOTTOM PLATE
Insert the projection on the bottom plate
into the groove on the nozzle housing
and set the bottom plate in place.
4
Turn the vacuum over and place in the upright
2
2
Using a Philips screwdriver, loosen
the screw on the bottom plate and
slide the locking latch to the left.
3
Push on the two (2) locking tabs at
the rear of the left and right side of the
base to release the bottom plate and
lift the base off.
position.
Press on the bottom plate so that
the two (2) locking tabs snap in place.
Slide the locking latch to the right and
re-tighten the screw using a Philips
screwdriver.
3