Filter
Top Products
1
1
2
2
3
3
4
5
Nozzle
Pipe
Scissors
Threads
CLEARING BL OCKAG ES IN THE SUCTION HOSE
AND CL EANING THE AG ITATOR ASSEMBLY
Caution: Be sure to turn the ON/OFF switch to the" OFF " position and disconnect
the power cord from the wall outlet before clearing any blockages in the
suction hose and cleaning the agitator assembly.
Clearing blockages in the suction hose
Set the vacuum cleaner to the upright position.
Remove the hose cuff from the suction inlet and
then remove any blockages from the hose.
Reattach the hose cuff to the suction inlet,and
then operate the vacuum cleaner to check that
the blockage has been properly cleared.If the hose
is still blocked,the suction force will be weak.
If the hose still appears to be blocked:
Set the vacuum cleaner to the parallel position and turn it over.
Remove the lower hose joint from the lower
suction inlet as shown above.
Remove the bottom plate.
(refer to page15)
Remove any blockages in the nozzle pipe,
while being extremely careful not to damage it .
Re -install all the parts in the reverse order of removal.
(For the procedure for reattaching the bottom plate,
refer to page15)
Caution :
Check that all parts have been installed correctly before reattaching the bottom plate.
Firmly and securely insert the lower hose cuff.
Cleani ng the agitat or assem bly
When threads get caught in the agitator assembly,clean the assembly.
Remove threads caught in the assembly by cutting them
with scissors.
11
Hose Cuff
Suction lnlet
1
2
Hose
Joint