Filter
Top Products
Getting To Know Your Air Purifier
Technical Specifications
Voltage: 120V., 60Hz.
Power: 108 Watts
Area Coverage: 300 sq ft
4
1. Remote Control*
2. Air Intake Grill
3. Dust Sensor
4. Odor Sensor
5. Pre-Filter & HEPA Filter
Note: Illustrations may differ from actual unit.
* Please note that the 2 AAA batteries required for the remote control
are not included.
6. UV Light Protector
7. UV Light
8. Neutralizer
9. Main Unit
10. Air Outlet Grill
OPERATING INSTRUCTIONS
Replacing the UV Bulb
9
The Air Purifier is equipped with two
UV bulbs. These bulbs will last
approximately 8,000 hours (almost
one (1) year of continuous use with
the neutralizer activated).
1. Lay the unit down with face of unit
upwards.
2. Grasp both corners of the bottom
of the air intake grill and pull
upwards. (Fig. 14)
6. Gently rotate the bulb one quarter
turn clockwise until the bulb pins
unlock from the socket. (Fig. 17)
7. Pull the pins out of the sides of the
socket one end at a time.
Fig. 14
3. Lift air intake grill gently towards
top of unit to remove.
4. To remove the HEPA filter, pull up
on the tags on either side of the
filter and lift upwards. (Fig.15)
Fig. 15
Protective Shade
T5 Base
Fig. 17
8. Unpack the new bulb carefully,
handling only the base and not the
bulb. Place the new bulb into the
socket with the pins pointing
upwards. (Fig. 18)
Important: Oil from hands left on
the bulb could interfere with the
germicidal action and life of the bulb.
9. Rotate the new bulb one quarter
turn counter clockwise to lock bulb
into place.
10.Replace protective shade and
screw in the screws. (Fig. 19)
Fig. 18
NOTE: Ensure that no packing material
has been left in the unit before replacing
the HEPA filter.
11.Replace HEPA filter and cover on
unit.
Bulb Replacement:
Philips TUV 8 Watt T5 base. (Fig. 20)
Call Customer Service at
1 (800) 275-9251 for more information
on bulb replacements.
CAUTION: Use care when removing
the bulb. Always turn bulb from the
base and not the light bulb.
Fig. 19
Fig. 20
Screw
Fig. 16
5. There is a protective shade
covering the UV bulbs. To remove
the protective shade use a Phillips
#2 screw driver to remove the
screw on either end of the shade,
then lift the shade off. (Fig. 16)