Filter
Top Products
ENGLISH
• 4 •
MOUNT FILTER HEAD UNDER SINK
Identify Filter Head and the two Elbow Fittings, and
note that the Outlet Fitting has a black band. This fitting
includes a small restrictor insert to insure maximum
flow at 1/2 gallon per minute.
Apply Teflon Tape to the threads of each Elbow Fitting.
Wrap tape in direction of the threads to assure a tight fit
and avoid small leaks.
Screw Inlet Elbow Fitting into the left side of the filter
head, and hand tighten only.
Screw Outlet Elbow Fitting (black band) into the right
side of the filter head in the same manner.
Securely mount the filter head on the cabinet wall using
the enclosed mounting screws and washers.
ATTACH INLET WATER SUPPLY
Locate and close the cold water Angle Stop Valve under
your kitchen sink. Open cold water line of faucet to
release water pressure.
Unscrew and disconnect the braided tubing on top of the
Angle Stop Valve .
Attach the bottom of Angle Stop Adaptor to the existing
cold water Angle Stop Valve.
Attach the braided tubing to the top of the Angle Stop
Adaptor.
Close side valve on Angle Stop Adaptor and open cold
water Angle Stop Valve to return water service to
kitchen sink. Check for leaks.
NOTE: Teflon
®
Tape should not be required for these
next steps.
Measure length of tubing needed to connect Angle
Stop Adaptor to Inlet Elbow Fitting on Filter Head. Allow
adequate tubing to avoid sharp turns.
Cut tubing at a 90° angle using a sharp knife.
Insert ends of tubing into quick-connect fittings. Push
tube into fitting and gently pull to confirm a tight fit.
ATTACH FILTERED WATER TO SINK FAUCET
Install separate faucet for filtered drinking water. Follow
individual manufacturer’s instructions.
Attach Faucet Connector Fitting to bottom end of
threads on new faucet assembly. Teflon
®
Tape should
not be required for this step.
Measure length of tubing needed to connect the
Outlet Elbow Fitting on Filter Head to the new Faucet
Connector Fitting. Allow adequate tubing to avoid sharp
turns. Cut and insert each end of the tubing into the
fittings.
OPTIONAL FILTER MONITOR (H300+M Filter System)
A Filter Replacement Monitor (EV3112-01) is included with the
H300+M Filter System. It is a small water meter that counts the
number of gallons used. This Monitor includes quick-connect
fittings, and should be installed on the tubing between the filter
system and the faucet connector.
Monitor Instructions (Document EV3112-52) are included with
the H 300+M System.
3.
A.
B.
C.
D.
E.
1.
F.
G.
H.
I.
J.
K.
L.
M.
5.
N.
O.
P.
3
B
C
D
E
G
H
I
L
M
4
F
P
O
N
5