Filter
Top Products
Charging Instructions
1. Connect the charger plug to the charging jack or hole on the backside of the
sweeper. Plug the charging adapter into the wall outlet. (120V., 60Hz.) Use only
K-TEC Charger KA12D075015023U. (Fig. 2)
4
Operating Instructions
2. This cordless sweeper is powered by Ni-Cd batteries. Before first use, they must
be charged for a minimum 20 hours.
3. When recharging the unit, the unit must be turned off.
4. The charging light indicator on the top of the sweeper will illuminate to indicate
that the sweeper is properly charging.
5. To recharge, repeat step #1 above. Charging times will vary depending upon the
amount of usage between charging cycles.
Note: If when you place the sweeper to recharge and the charging indicator light
does NOT illuminate, then press the On/Off button once to turn the sweeper off. The
charging indicator light should now light up.
Note: Peak performance may only be realized after the unit has been charged and
discharged two (2) or three (3) times.
Important: To maintain peak performance of your cordless sweeper, it is
recommended that the unit be fully discharged, then completely re-charged at least
once a month.
Caution:
• Use only the adaptor supplied with the sweeper.
• Do not clean the sweeper while unit is charging.
• Do not attempt to remove the battery pack from the unit to charge it.
• Never attempt to throw the battery pack or unit into a fire or incinerate it.
• Do not attempt to remove or damage the battery casing.
Fig. 2
How To Operate Your Cordless Sweeper
1. Before using, please ensure that the cordless sweeper has been initially
charged for 20 hours. Your cordless sweeper wil
l only operate properly when the
batteries are fully charged. Your sweeper wil
l operate for varying lengths of time
on a full charge. This will depend upon the type of surface being cleaned (longer
operating time on bare floors vs. carpets).
2. Push the On/Off switch to operate the unit. To turn off, press switch again. (Fig. 5)
7
Operating Instructions
3. To release the handle to a comfortable position, gently apply pressure to
the top of the sweeper head with your foot while pulling back on the handle.
(Fig. 6)
Fig. 6
On/Off Button
Fig. 5
Charging
Light
Indicator