Euro-Pro EP923H Carpet Cleaner User Manual


 
GETTING TO KNOW YOUR STEAM CLEANER WITH
SOAP DISPENSER
1. Safety Filler Cap
2. Shoulder Strap
3. Power “On” Light (Red)
4. Steam Ready Light (Green)
5. Flexible Hose
6. Steam Switch
7. Locking Button
8. Power Cord
9. Front Locking Tab
10. Caddy
11. Rear Locking Latch
12. Hand Grip Storage
13. Castors (x4)
14. Extension Tubes (x2)
15. Window Squeegee
16. Steam Pocket Frame
17. Steam Pocket
18. Pump Button
19. Soap Dispenser
20. Triangular Brush
21. Wall Paper Scraper
22. Concentrator For Wall Paper Scraper
23. Concentrator
24. Nylon Bristle Brushes (x2)
25. Brass Bristle Brush
26. Funnel
27. Soap Accessory Adapter
28. Small Pad Base
29. Large Pad Base
30. Small Scrubbing Pad
31. Large Scrubbing Pad
32. Small Sponge Pad
33. Large Sponge Pad
34. Sample Bottle of Soap (8 oz.)
TIPS ON HOW TO USE YOUR SYSTEM
Note: Soap scum sometimes will develop
a hard surface from waterborne minerals.
If this is the case, use the floor brush with
no towel first to break up this surface - or
spray or wipe first with lemon, vinegar or
seltzer soda water to soften the minerals.
Moving too slowly can dry out the soap
scum and cause it to granulate on the
surface. The surface will have a gritty
feel. If this happens, apply vapor to the
surface with the open brush again and
re-clean.
Bathroom Areas
To clean the bathtub or shower area, use
the nylon bristle brush for grout, shower
door tracks, hard to get areas and heavily
soiled areas. The dual edge window/tile
squeegee will be the most efficient way
to clean the rest of the area. Allow plenty
of time for the heat to penetrate the
surface. This is especially helpful in the
shower area if there is tile or grout. Wipe
with towel.
Removal of soap scum on tile, grout, and
shower doors is also easier with the
steam cleaner.
Garden Furniture
Use any of the brushes depending on the
surface area. Work quickly when
cleaning resin outdoor furniture. Finish by
wiping with a towel
Blinds
Use the nylon bristle brush to clean
blinds. Move the brush over the surface,
allowing enough time for the vapor to
penetrate. Work quickly on PVC blinds.
Test for color fastness on fabric blinds
before using. Finish by wiping with a
towel.
Automotive
For detailing the wheels, use the
concentrator and the brass bristle brush.
Exterior windows are cleaned best by
applying the vapor with the concentrator
and following with a paper towel.
To clean bicycles, use the nylon bristle
brush.
To clean equipment, use the bristle
brush, depending on the surface area.
Finish by wiping down with a towel.
Upholstery
Use the triangle brush attached directly
to the hand grip with a clean white terry
cloth towel. Use fast, light strokes, avoid
getting the fabric wet. Be patient with
stubborn spots; work on a spot gently for
no more than a minute at a time, then
wait five minutes for the area to dry and
repeat. Use circular movements or back-
and-forth and side-to-side movements to
get all sides of surface fibers then blot
with a towel. Finish with a brushing in
one direction that will give the fabric a
uniform appearance.
CAUTION: Always determine
the color-fastness of any fabric-
especially with reds or blues - by taking a
clean, moist, warm towel and gently
rubbing a small area as far down on the
back or other out of the way place on the
furniture as possible. If color comes off
on the towel, you may need to have the
piece dry cleaned.
Window, Glass Surfaces and Mirrors
Use the dual edge glass and tile
squeegee. Work with the vapor jet on
using the top to bottom movements. Use
the squeegee with the vapor off to clear
the water from the glass. To do this
without leaving streaks, use lateral
movements from the top to the bottom of
the surface.
CAUTION: When cleaning
windows, always avoid any sudden
changes in temperature to prevent glass
breakage or cracks.
Fiberglass or Stainless Steel Surfaces
Use the triangle brush or nylon bristle
brush. Slowly move the brush over the
surface to be cleaned. The vapor will
emulsify the dirt and grease on the
surface. Follow behind with a terry cloth
towel over the brush to remove excess
moisture and residue.
Tip: An old idea for polishing stainless
steel is to wipe it down with seltzer soda
water after it is cleaned.
Soap Scum
Soap scum dissolves almost immediately
under a combination of heat and
moisture. Rinse the surface with a small
amount of water afterwards or go back
over it once more with a clean terry cloth
towel.
Technical Specifications
Voltage: 120V., 60Hz.
Power: 1550 Watts
Water Capacity: 40 US Fl. Oz. (1200 ml.)
Steam Generator: Stainless Steel
* Illustrations may differ from actual product.
3
14