Filter
Top Products
3. Before you start vacuuming,
make sure to remove large or
sharp objects that might
damage the vacuum.
5. Do not pick up anything that is
burning or smoking such as
cigarettes, matches or hot ashes.
1. Do not operate the vacuum
cleaner too close to heaters or
radiators.
PRECAUTIONARY MEASURES
Parking
Position
Support
Parking
Position
Bracket
Fig. 18
TROUBLE SHOOTING GUIDE
OPERATING INSTRUCTIONS
Flat & Upright Parking Position
Important: If the suction opening of the unit, the hose or the chrome telescopic tube
are BLOCKED
, switch off the vacuum cleaner and remove the blocking
substance before you start the unit again.
Please note that your vacuum cleaner
can be conveniently placed in a space
saving vertical parking position.
For vertical parking position, place the
vacuum on its side and slide the
parking position bracket that is on the
telescopic tube into the parking
position support that is on the
underside of the vacuum. (Fig. 18)
4. When pulling out the power plug
from the wall outlet, pull the plug
not the power cord.
TROUBLESHOOTING GUIDE
PROBLEM POSSIBLE REASON POSSIBLE SOLUTION
Motor runs but no
suction
1. Hose, wand or inlet is
blocked.
2. Check bag full indicator.
3. Hose clamp not assembled to
hose inlet properly.
1. Check for blockage - remove it.
2. If dust bag is full, replace dust
bag.
3. Insert hose clamp into hose inlet
until "snap" locks for proper
assembly.
Cord does not
rewind
1. Cord twisted.
2. Cord pulled out too far -
beyond "RED" mark.
1. Pull cord out, straighten and
rewind again.
2. Holding the plug, press the
rewind button and try to rewind
again.
Cleaner won't run
1. Not firmly plugged in.
2. No electricity in wall outlet.
3. Blown fuse/tripped breaker.
4. Motor thermostat may have
tripped.
1. Plug unit in firmly.
2. Check fuse or breaker.
3. Replace fuse/reset breaker.
4. Allow unit to cool down before
trying to switch "ON" again.
Turbo brush does
not rotate or
rotates slowly
1. Rotating brush or elbow
obstructed.
2. Hose obstructed.
3. Dust bags full.
4. Filters need changing.
1. Clear obstrucitons.
2. Clear obstruciton.
3. Replace dust bag.
4. Replace filters.
2. Before inserting the power plug
into the wall outlet, make sure that
your hands are dry.
6. Do not use without all filters and
paper dust bag in place.
Note: This vacuum cleaner is equipped
with a plug and power cord that retract
automatically. If the cord or plug get
damaged, it must be replaced by a
qualified technician.
Warning: Hold the plug when
rewinding the cord. Do not allow
the cord to whip
when rewinding.
8
3