Filter
Top Products
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
Assembling Your Vacuum Cleaner
4. Fitting the Floor to Carpet
Brush or the Air Driven Turbo
Brush to the Telescopic Tube
Push the telescopic tube into the
desired floor brush as show in the
illustration below.
2. Fitting the Chrome
Telescopic Tube to the
Curved Wand / Hose
Extension
Push the chrome telescopic tube
into the curved wand / hose
extension, as shown in the
illustration below.
Plastic
Button
3. Extending the Chrome
Telescopic Tube
Push forward on the plastic button
and pull the inner chrome tube
outward.
Floor to Carpet
Nozzle
Air Driven Turbo
Brush
5. Air Driven Turbo Brush
The efficiency of your Air Driven
Turbo Brush depends on the bristle
brush rotating at high speed. Strong
air suction is needed to accomplish
this. In order to ensure that
maximum air suction is maintained,
please read the following instructions:
• Empty the Dust Cup frequently during
use.
• Always “TapClean” the HEPA dust
cup filter each time the dust cup is
emptied.
• Ensure that the rotating bristle brush
is kept free of hair and string.
• Inspect the turbine regularly to ensure
that the air passage is free of dirt and
debris. See cleaning instructions on
page 8.
Note: Always remove the power plug
from the wall outlet before assembling or
removing accessories.
4
1. Attaching the Flexible Hose
into the Vacuum
Connect the flexible hose into the
hose connector inlet. Push in until
you hear a “click”, indicating it is in its
locked position.
Telescopic
Tube
Important
: The suction hole must be
open, free of any obstructions at all
times. Otherwise, the motor will overheat
and could become damaged.
filter material in the HEPA Dust Cup
Filter will discolor over time -This is
NORMAL and will NOT affect the
performance of the filter. If the HEPA
Dust Cup Filter
is properly
"TapCleaned”
after each use
and suction
does not return
to 100%, then
we suggest that
the HEPA filter
be “TapCleaned”
vigorously until
no more dust
can be removed, then rinsed under
the faucet and allowed to dry for 24
hours before refitting into the vacuum.
(Fig. A) This should be done once a
month or when suction appears to
be reduced.
Fig. A
Warning: Allow 24
hours for drying before
replacing in unit.
Wash
once a
month or
when
suction
appears
reduced
Changing & Cleaning the
Pre-Filter
The pre-filter is located on the top of the
Rinseable "TapClean" HEPA filter. See
illustration below.
This is a rinseable filter but should be
replaced every six (6) months. Never
operate the vacuum without ALL the
filters in place.
• Push the Power On/Off button to the
"Off" position and disconnect the
power cord from the wall outlet.
• Open the dust cup cover and remove
the dust cup being careful not to press
on the trap door release button.
• Remove the HEPA filter and hold the
tab that is on the top of the filter and
pull until the filter cover snaps off.
• Rinse pre-filter in lukewarm water, let
dry completely. Do not use a washing
machine to rinse the filter. Do not use
a hair dryer to dry it. Air dry only.
• Replace only when the pre-filter is
completely dry, replace into HEPA
filter and snap the cover back in
place.
PLEASE NOTE
: The white pleated
11.Insert the Rinseable
"TapClean" HEPA dust cup
filter back into the dust cup.
12.Re-install dust cup into the
vacuum. Close cover and re-
attach hose.
9. Vigorously “TapClean”
the HEPA Dust Cup
Filter on a hard
surface until no more
dust is observed
falling out from
between the pleats of
the filter. See
illustration at right.
IMPORTANT
: Please note that there
is a safety switch inside the vacuum
where the dust cup is inserted to
prevent the unit from being run
without a dust cup filter in place. If the
dust cup filter has not engaged this
safety switch, the vacuum will NOT
operate. Therefore, ensure that the
dust cup filter is inserted firmly into the
vacuum when assembling.
10.Reassemble the debris screen to the
HEPA filter cartridge and replace into
dust cup (container). Ensure that the
filter assembly is completely seated
inside the dust cup (container).
Important: Do NOT use the HEPA filter
cartridge without the debris screen in
place.
7