Filter
Top Products
PRECAUTIONARY MEASURES
OPERATING INSTRUCTIONS
1. Do not operate the vacuum
cleaner too close to heaters or
radiators.
5. Do not pick up anything that is
burning or smoking such as
cigarettes, matches or hot ashes.
4. When pulling out the power plug
from the wall outlet, pull the plug
not the power cord.
Important: If the suction opening of the unit, the hose or the chrome telescopic tube
are BLOCKED
, switch off the vacuum cleaner and remove the blocking
substance before you start the unit again.
Changing & Cleaning the
Pre-Motor Filter
The pre-motor filter is located behind the
dust cup. See illustration below.
This is a rinseable filter but should be
replaced every six (6) months. Never
operate the vacuum without ALL the
filters in place.
• Push the Power On/Off button to the
"Off" position and disconnect the
power cord from the wall outlet.
• Open the dust cup cover.
• Remove the pre-motor filter and rinse
in lukewarm water, let dry completely.
Do not use a washing machine to
rinse the filter. Do not use a hair dryer
to dry it. Air dry only.
• When filter is completely dry, replace
pre-motor filter back into the unit and
close the dust cup cover.
Please Note: The HEPA Dust Cup
Filter is washable. It should, however,
be replaced every six (6) months to
ensure peak performance of your
vacuum.
The Post Motor Filter, Pre-Motor Filter
and Pre-Filter are washable. They
should however be replaced every six
(6) months to ensure peak performance
of your vacuum.
Important:
Make sure that ALL filters
are completely dry before re-installing
back in the hand vacuum.
Important:
All filters should be checked
regularly for signs of damage,
preferably after each cleaning task. The
filters must be replaced immediately if
they become damaged. Always
disconnect the vacuum from the
electrical outlet when checking the
filters.
2. Before inserting the power plug
into the wall outlet, make sure that
your hands are dry.
6. Do not use without all filters in place.
Cleaning Air Driven Turbo Brush
1. On the base of the turbo brush there is
an access door for the turbine. To
open for cleaning, push latch toward
door and lift door off.
2. Inspect turbine wheel and air passage
for debris and/or blockage. Remove
debris if present.
3. Inspect the rotating brush for built-up
hair or string. If present, remove by
carefully cutting with scissors. Avoid
damaging or cutting bristles.
4. Once clean, snap the turbine access
door back in place. The turbo brush
will not function without the access
door in place.
Note: This vacuum cleaner is equipped
with a plug and power cord that retract
automatically. If the cord or plug get
damaged, it must be replaced by a
qualified technician.
3. Before you start vacuuming,
make sure to remove large or
sharp objects that might
damage the dust bag.
Warning: Hold the plug when
rewinding the cord. Do not allow the
cord to whip when rewinding.
Changing & Cleaning the Post
Motor Filter
The post motor filter is a washable filter
but should be replaced every six (6)
months depending on usage. Never
operate the vacuum without ALL the
filters in place.
• Push the Power On/Off button to the
"Off" position and disconnect the
power cord from the wall outlet.
• The post motor filter is located on the
rear of the vacuum. Remove the filter
from the filter grill.
• Rinse in lukewarm water, let dry
completely. Do not use a washing
machine to rinse the filter. Do not use
a hair dryer to dry it. Air dry only.
• When filter is completely dry, replace
post motor filter back into the unit and
replace the filter cover.
3
8