Filter
Top Products
PRECAUTIONARY MEASURES
IMPORTANT: If the suction opening in the unit or the nozzle is BLOCKED,
switch off the vacuum cleaner and remove the blocking
substance before you start the unit again.
1. Do not operate the vacuum cleaner
too close to heaters, radiators or
cigarette butts.
2. Before inserting the power plug into
the wall outlet, make sure that your
hands are dry.
4. When pulling out the power plug
from the wall outlet, pull the plug not
the power cord.
3. Before you start vacuuming, make
sure to remove large or sharp objects
that might damage the dust cup.
5. Do not pick up anything that is
burning or smoking such as
cigarettes, matches or hot ashes.
6. Do not use without filter in place.
3
6
TROUBLE SHOOTING GUIDE
OPERATING INSTRUCTIONS
IMPORTANT: This unit is equipped
with a motor protective thermostat. If
for some reason the vacuum cleaner
should overheat, the thermostat will
automatically turn the unit off. Should
this occur:
• Push the On/Off button once.
• Disconnect the plug from the
power source.
• Check the source of overheating
problem. (i.e. clogged hose or
filter)
Motor Thermostat
• If clogged hose or filter is found,
unclog the hose and replace the
filters.
• Wait at least 45 minutes before
attempting to reuse the vacuum.
• After unit has cooled down for
45 minutes, plug in the cleaner
and push the On/Off button. The
vacuum should start again.
• If the vacuum still does not start,
contact customer service at
1 (800) 798-7398.
PROBLEM POSSIBLE REASON POSSIBLE SOLUTION
VACUUM WILL
NOT OPERATE
1. Power cord not firmly plugged into
outlet.
2. No power in wall outlet.
3. Needs servicing.
4. Thermostat has tripped.
1. Plug unit in firmly.
2. Check fuse or breaker. Replace
fuse/reset breaker.
3. Call 1 (800) 798-7398.
4. Turn the unit off and unplug from
outlet. Allow unit to cool down,
then restart.
VACUUM WILL
NOT PICK-UP OR
SUCTION POWER
IS WEAK
1. Dust cup is full.
2. Unit clogged.
3. Filter needs cleaning or replacing.
1. Empty and clean dust cup.
2. Turn unit off and unplug from
wall outlet. Remove dust cup
filter and check for object(s) in
the air intake opening and
remove.
3. Clean or replace filter.
DUST ESCAPING
FROM VACUUM
1. Dust cup is full.
2. Dust cup is not installed correctly.
3. Filter is not in unit.
1. Empty and clean dust cup.
2. Review dust cup instructions.
3. Install filter in unit.
BRUSH OR FLOOR
NOZZLE WILL NOT
PICK-UP
1. Brush or floor nozzle is clogged.
2. Dust cup is full.
3. Filter need cleaning or replacing.
1. Remove brush and/or floor
nozzle. Remove obstruction
from brush and /or floor nozzle.
2. Empty and clean dust cup.
3. Clean or replace filter.