Filter
Top Products
Changing & Cleaning the Exhaust
Filter
The exhaust filter is a rinseable filter but
should be replaced every three (3)
months.
• To remove the exhaust filter cover,
depress the filter cover lock and pull
the filter cover out. Remove the filter.
(Fig. 17)
• Rinse the exhaust filter in lukewarm
water and air dry the filter completely
for 24 hours. Do not use a washing
machine to rinse the filter. Do not use
a hair dryer to dry it. Air dry only.
Never operate the vacuum without the
exhaust filter in place.
• When the filter is dry, replace into
the exhaust filter cover and replace
on the vacuum.
• A severely soiled or clogged filter
should be thoroughly rinsed with fresh
tepid water. A mild detergent can be
used if required.
PRECAUTIONARY MEASURES
IMPORTANT: If the suction opening in the unit or the hose is BLOCKED, switch off
the vacuum cleaner and remove the blocking substance before you
start the unit again.
1. Do not operate the vacuum cleaner
too close to heaters, radiators or
cigarette butts.
2. Before inserting the power plug into
the wall outlet, make sure that your
hands are dry.
4. When pulling out the power plug
from the wall outlet, pull the plug not
the power cord.
3. Before you start vacuuming, make
sure to remove large or sharp objects
that might damage the dust cup
debris screen.
5. Do not pick up anything that is
burning or smoking such as
cigarettes, matches or hot ashes.
6. Do not use without ALL filters in
place.
3
Warning: Always empty the
dust cup container and clean
the HEPA filter and Debris Screen
before each use and during
prolonged usage.
Please Note: The HEPA Filter is
washable. It should, however, be
replaced every three (3) to six (6)
months to ensure peak performance of
your vacuum.
The exhaust filter and filter ring are also
rinseable but they should be air dried
for 24 hours before replacing into the
vacuum. They should however be
replaced every three (3) months to
ensure peak performance of your
vacuum.
Important:
Make sure that ALL filters
are completely dry before re-installing
back in the vacuum.
8
Never over fill the dust cup container -
remove dirt and clean the HEPA filter,
filter ring and debris screen when dirt
in dust cup is at or below the "MAX"
level or during prolonged usage
because you could risk damaging the
motor.
If you wash the Hepa filter and filter
ring, make sure that they have
completely air dried for 24 hours
before inserting back into the
vacuum.
OPERATING INSTRUCTIONS
Exhaust
Filter
Cover
Fig. 17
Filter
Cover
Lock
Cleaning the Filter Ring
1. Around the HEPA filter
there is a filter ring.
This is washable in
lukewarm water.
(Fig. 16) To remove
the filter ring, slide it
off the HEPA filter.
2. We recommend
washing the filter ring
when you are
washing your HEPA
filter. Always allow the
filter ring to air dry for
24 hours before replacing onto
the HEPA filter. Never run the vacuum
without all the filters in place.
Note: This is a washable filter, but we
recommend replacing it every three (3)
months.
Fig. 16