Filter
Top Products
Post-motor filter
Pre-motor filter
Replace Dust Filters
Pre-Motor Filter
Your vacuum cleaner is equipped with a filtration system to reduce dust and pollen in your home as you
clean. The white pre-motor filter is located inside the vacuum body behind the dust bag. Check when
changing the dust bag and replace when dirty.
To replace, lift vacuum body cover, then pull the white polyfoam straight up and out of the vacuum body,
dispense of old filter. Hold new filter with narrow round side down and slide into position between the
two posts and the motor intake.
Post-Motor Filter
1. Remove rear filter by grasping edge, squeezing and pulling towards you. The top of the cover
will become loose and you can remove it by pulling at a slight angle.
2. Remove filter and dispose of filter.
3. Insert new filter, making certain to position it over entire air vent area.
4. Replace rear filter cover by placing the four tabs into the four slots at the bottom of the filter
opening. Push top of cover until it snaps into place.
To order additional bags and filters or for customer service:
Call EURO-PRO Customer Service at: 800-798-7398
514-842-8691
or Fax to: 514-842-6985
Monday to Friday 8:30 AM – 5:00 PM Eastern Standard Time
Replacement set of 2 Cloth Bags and 2 sets of Filters: $10.95 + $3.95 Shipping & Handling
Replacement set of 10 Paper Bags and 2 sets of Filters: $ 9.95 + $3.95 Shipping & Handling