Euro-Pro EP035H3 Vacuum Cleaner User Manual


 
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
Using The Unit With Air
Driven Turbo Brush
Warning: Always unplug from
electrical outlet before opening the dust
cup (container).
Note: HEPA dust cup filter must be
used when operating the hand vacuum.
How To Operate Your
Hand Vacuum
1. Hold the hand vacuum firmly in
your hand by the Handle.
2. Push the On/Off Power Switch to
“On” position.
3. Start vacuuming.
CAUTION: The Hand Vacuum is
a very powerful unit. Make sure
that you hold it firmly, otherwise it
can slip out of your hand and
cause injury.
4. To use the flexible hose, push
the end of the hose into the
suction hole, then attach the
desired brush to the other end
of the flexible hose, as shown
below.
NOTE: When the Intelli-Sense
Filter Monitor
TM
lights up, it means
that the dust cup is full or filter
needs cleaning. You must empty
the dust from the dust cup and
clean the HEPA dust cup filter right
away. (See illustration below.)
5. Ensure that the turbine wheel moves
freely by rotating it with your finger. If
the turbine does not rotate, call
Customer Service for help.
6. Close and lock the hinged cover on the
turbo brush and continue vacuuming.
The efficiency of your air driven turbo
brush depends on the bristle brush
rotating at high speed. Strong air suction
is needed to accomplish this. In order to
ensure that maximum air suction is
maintained, please read the following
instructions:
1. Empty the dust cup frequently.
2. Always "TAPCLEAN" the HEPA dust
cup filter when emptying the dust cup
container.
3. Ensure that the rotating brush is kept
free of hair and string which may
accumulate and decrease brush
performance.
4. Keep Air Driven Turbo Brush turbine
free of dirt and foreign matter. (See
illustration below for cleaning
instructions.)
Using The Unit As A Hand
Vacuum
Cleaning & Changing the
HEPA Dust Cup Filter
1. To open the dust
cup (container),
push button and
pull out the dust
cup. Verify that the
HEPA dust cup
filter is inside, then attach the
dust cup (container) to the
hand vacuum.
Warning: Always unplug the unit from
electrical outlet before opening the Dust
Cup (container).
Important: Do NOT use the HEPA filter
cartridge without the debris screen in
place.
Warning: After each Use - Always
remove the Filter Debris Screen from the
HEPA Dust Cup Filter, then vigorously
TapClean” HEPA Filter until no more
dust can be removed.
Cleaning Air Driven Turbo
Brush
Turbine
Wheel
Tilt
Upwards
Locking
Latch
Fig. 1
IMPORTANT, Please Note : The
“TapClean” HEPA Dust Cup Filter &
Debris Screen will stop most of the tiniest
dust particles from re-entering the air you
breathe. In fact it stops 99.97% of all
particles as small as 0.3 microns - many
times smaller than a human hair!!!
Because of this incredible filtration
performance, the HEPA Dust Cup Filter
will quickly accumulate, inside the white
filter folds, many fine dust particles that
are difficult to see but which will eventually
block or reduce your suction power - if not
cleaned properly. Clean the HEPA Filter
and Debris Screen after each use as
described in this section.
2. To use the Hand Vacuum with the
shoulder strap, attach it to the unit as
shown below.
3. To attach the oval brush, air driven
turbo brush or the pet hair removal
attachment to the Hand Vacuum,
push attachment into the suction
hole, as shown below.
From time to time, the turbine of your
turbo brush will require cleaning. To do
this:
1. Remove the turbo brush from the hose
or unit.
2. Turn turbo brush over and open the
hinged cover to access the turbine
wheel. (see fig. 1)
3. There may be some dust, lint, hair, etc
on the turbine wheel. Remove as much
of this as possible.
4. You may also use the unit’s hose to
remove any additional debris from the
turbine.
1. To open the Dust Cup (container),
push button and detach the Dust
Cup (container ). (Fig. 2)
2. Pull out the HEPA Dust Cup Filter.
(Fig. 3)
Fig.3
Fig. 2
NOTE: The pet hair removal
attachment is for use on
upholstery, drapes and other fabric
surfaces to remove lint, pet hair,
etc. THE PET HAIR REMOVAL
ATTACHMENT IS NOT
INTENDED TO BE USED AS A
PET GROOMING DEVICE.
4
5