Filter
Top Products
GETTING TO KNOW YOUR BACK PACK VACUUM
Technical Specifications
Voltage: 120V., 60Hz.
Power: 12 Amps
* Note: Illustrations may differ from actual product.
3
1. Main Unit
2. Exhaust Grill
3. On/Off Power Switch
4. Canister Lid Tabs
5. Waist Band
6. Shoulder Straps
7. Back Board Panel
8. Carry Handle
9. Hose Inlet
10. Canister Lid
11. Flexible Hose
12. Flexible Hose Handle
13. Variable Suction Control
14. Telescopic Tube Release Button
15. Telescopic Tube
16. Waist Band Back Support Panel
17. Waist Band Tool Carrier
18. Dusting Brush
19. Crevice Tool
20. Blower Port
21. Pet Hair Remover
22. Floor to Carpet Brush
23. Air Driven Turbo Brush
24. Blower Attachments (x3)
25. HEPA Dust Bag
26. Shake-Out Bag
27. HEPA Pre-Motor Filter
28. Exhaust Filter
OPERATING INSTRUCTIONS
10
Motor Thermostat
Important: This unit is equipped with
a motor protective thermostat. If for
some reason the vacuum cleaner
should overheat, the thermostat will
automatically turn the unit off. Should
this occur:
• Turn the unit off.
• Disconnect the plug from the power
source.
• Check the source of overheating
problem. (i.e. clogged hose, full dust
bag or filter).
• Wait at least 45 minutes before
attempting to reuse the vacuum.
• After unit has cooled down for 45
minutes, plug in the cleaner and
turn the unit on. The vacuum
should start again.
• If the vacuum still does not start,
contact customer service at:
1 (800) 798-7398.
The HEPA pre-motor filter should be
replaced every three (3) to six (6)
months to ensure peak performance of
your vacuum.
Changing & Cleaning the
Exhaust Filter
Note: The exhaust filter is located in
the front of the vacuum.
Important Note: This filter is a
washable filter and can be cleaned by
rinsing under lukewarm water.
Always allow the exhaust filter to air dry
for 24 hours before replacing in the
vacuum. Do not use a hair dryer to dry
it. Air dry only. To remove the exhaust
filter:
1. While pushing up the exhaust tab,
pull out the exhaust grill. (Fig. 25)
Fig. 25
Exhaust
Grill
Exhaust
Tab
Warning: To reduce the risk of electric shock, the power cord must be
disconnected before removing the dust bag, shake-out bag,
changing the filters or performing maintenance or trouble-
shooting checks.
2. Remove the exhaust filter.
3. Clean the exhaust filter by rinsing
under lukewarm water.
4. After air drying for 24 hours, replace
into the vacuum.