Filter
Top Products
6
1-800-282-2886
Routine Maintenance (continued)
Installing New Dust Bag:
Periodic Maintenance
NOTE: Turn off the switch and unplug the electrical
cord before periodic maintenance. Never
operate the vacuum cleaner without the dust
bag or lter assembly in place.
Brush Roll
The brush roll turns as it sweeps and combs the carpet nap.
Remove hair and threads from the brush roll so it continues
brushing the carpet. To maintain the most efcient cleaning,
the bristles must touch the carpet. To test the bristle length,
hold a ruler against the underneath side of the cleaner. If the
bristles no longer touch the ruler, replace the brush roll.
Brush Roll Belt, Style U
The brush roll belt turns the brush roll to agitate, sweep, and
comb the carpet nap. Check the belt regularly to be sure it is
in good condition. Replace the belt if it stretches, cracks or
loses tension. Cut away any hair or threads wound around
the brush roll or the belt pulley because the buildup could
cause the belt to rotate unevenly.
How To Replace Brush Roll Belt
1. Lower handle to oor to change belt.
2. Remove the two screws from the top of the hood.
3. Lift hood to remove.
4. Lift left end of brush roll.
5. Remove and discard belt.
6. Place new belt around motor shaft.
7. Place new belt around brush roll pulley.
8. Align left end cap with base. Push end cap securely into
place.
9. Pull right side of brush roll to stretch belt. Secure right
end cap into base.
IMPORTANT
10. Rotate brush roll by hand two full rotations to
properly position belt.
11. Place hood back on cleaner. Replace and tighten two
screws.
12. Return vacuum to upright position.
Fold dust bag aps of new
bag back and slide into unit.
Make sure inlet goes into
opening on dust bag.
Replace dust bag cover
on unit.
NOTE: Dust bag cover
cannot be closed
unless the dust bag is
installed properly.