Filter
Top Products
9
1. Turn the cleaner over. Pull up to remove bottom plate.
2. Lift out brush roll and discard old belt.
3. Fold new belt to slide it around the motor pulley.
4. Place belt around pulley end of brush roll.
5. Pull left end of brush roll down to stretch belt. Align the
end cap with the base and push down to secure.
6. Seat right end cap.
7. Turn the brush roll until the belt centers onto the brush
roll pulley.
8. Slant front of bottom plate to catch tabs into cleaner
slots. Push down above each hook to snap into place.
Use GENUINE EUREKA replacement belt, 54312.
GENUINE
EUREKA PRODUCT
Motor
Pulley
Look for the symbol.
For location of nearest Eureka
Warranty Station or Service
information call 1-800-282-2886.
Tabs
Slots
Pull
Pull
pp
pp
p
pp
pp
p
pp
pp
p
pp
pp
p
HOW TO MAINTAIN
The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the bag,
belt, and brush roll often.
Brush Roll
The brush roll turns to brush and sweep the carpet. Remove hair and threads from the brush roll so it can continue to brush
the carpet. To maintain the most efficient cleaning, the bristles must touch the carpet. To test the bristle length, hold a ruler
against the underneath side of the cleaner. If the bristles no longer touch the ruler, replace the brush roll.
Brush Roll Belt
The brush roll belt turns the brush roll as the bristles sweep
and brush the carpet. Check the belt regularly to be sure
it is in good condition. Replace the belt if it stretches, cracks
or loses tension. Cut away any hair or threads wound
around the brush roll or the belt pulley because the buildup
could cause the belt to rotate unevenly.
How to Replace Brush Roll Belt
NOTE: Turn off the switch and unplug the electrical
cord before replacing belt. Belt pulleys can
become hot during normal use. To prevent
injury, avoid touching the motor pulley when
checking the belt.
CAUTION: Improper installation of the brush roll
could cause carpet or cleaner damage.