Filter
Top Products
How to Replace Worn Belt or Light Bulb (On Some Models)
Note: Disconnect power cord and wands from electrical hose before replacing belt or bulb. Belt pulleys can become
hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt.
3. Lift out brush roll; replace new belt around brush roll
pulley.
2. Remove two screws located in front of the light bulb
and lift up to remove the brush roll cover.
1. Remove two screws from bottom side. Turn over to
grasp hood near handle socket and lift forward.
Replace headlight bulb, if necessary. Use GENUINE
EUREKA replacement bulb (refer to customer order
form).
Continue to step 2 to change belt. Skip to step 7
and 8 to replace hood on motorized nozzle.
5. Rotate belt onto motor pulley.
6. Replace brush roll cover.
Look for the symbol.
Use GENUINE EUREKA replacement belt, 58065.
7. Tilt cover over ridge and push down.
8. Secure with screws on underside (refer to 1).
Ridge
{
Brush
Roll
Pulley
Motor Pulley
{
14
4. Return brush roll into base.