Filter
Top Products
Eureka Customer Service HELPLINE 1-800-282-2886
www.eureka.com
4
1) Lower handle to floor and remove HEPA
filter (Fig. 7).
2) Unscrew the lens and remove old bulb.
Replace with bulb rated 12v., 10w.,
Type 904.
3) Push in new bulb, replace lens cover
and replace screw (Fig. 8).
4) Replace HEPA filter and cover; return to
upright position.
Change light bulb
(on some models)
Make sure vacuum is turned off and power cord is unplugged.
How to replace brush roll or belt
1) Use handle release to lower handle
flat onto floor (Fig. 1).
2) Remove 2 screws from the front side of
brush roll cover (Fig. 2).
3) Lift and remove brush roll cover (Fig. 3).
4) Remove brush roll and belt. Thread
new belt around motor shaft and right
end of brush roll (Fig. 4).
5) Pull right side of brush roll to stretch
belt. Secure right end cap into base
(Fig. 5). Align left end cap with square
in base and push into place.
6) Rotate brush roll 2 turns to center belt.
(Fig. 6).
7) Replace brush roll cover and 2
screws (Fig. 2).
!
Fig. 7
Fig. 8
How to Maintain Your Vacuum Cleaner
Make sure vacuum cleaner is turned off and power cord is unplugged
Check U belt. Replace if worn, cut or out of shape
Avoid touching the motor shaft when checking brush roll or belt.
!
!
Maintain brush roll
Motor can become hot with normal use.
Do not remove end caps. Remove hair and threads from brush roll periodically.
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 1