Filter
Top Products
55
HOW TO ASSEMBLE
CAUTION: Assemble the cleaner before using.
CAUTION: Moving parts, stay clear of brush roll when plugging in.
NOTE: Features may vary by model yet all parts assemble the same.
Step B Attach Handle
CAUTION: Do not catch cord under handle.
Step A Attach Hose
1. To attach hose, insert the hose adapter into the bag
compartment tube hole.
Bag Compartment
Tube Hole
Hose Adapter
2
2. From rear of cleaner, align handle with groove and
slide onto cleaner. If necessary, use thumb and finger
pressure to slide handle into position.
3. Attach handle with two 5/8 inch screws in the assembly
packet. Use either a slotted or Phillips
®
head
screwdriver.
4. Lift up on the hose adapter to be sure it is secured.
##
##
#
10. Place front cover by aligning tabs at bottom of front
cover into slots on cleaner. Pivot front cover toward
cleaner and push firmly, gripping at the top of the
bag cover, until latch is secure.
Groove
##
##
#
##
##
#
Push to
latch
Push
Step C Install Dust Bag (Some models may
have bag installed.)
5. Fold sides on new paper bag below bag collar.
6. Align bag collar hole and notch with hose tube.
7. Place rear of bag collar on ledges. Push back and
rotate upward until firmly in place.
8. Make sure collar snaps into position and hose tube
is securely inserted into bag collar hole. Tuck bag
into bottom and along sides.
9. Align front cover tabs and close cover. Make sure
paper bag is not caught under the front cover.
Step D Attach Bag Cover
Bag
Side
Bag
Collar
5
6
7
6
8