Filter
Top Products
To Change Cassette Micron Filter:
NOTE: Turn off the switch and unplug the electrical cord before changing the Cassette Micron Filter. Never operate
the vacuum cleaner without the cyclonic cassette or the filter.
Remove cyclonic cassette by pushing up lever (1), unhooking (2) by swinging
outward from vacuum body. When replacing cyclonic cassette, hook at top
where shown (2), and swing back into place until lever (1) snaps into place.
Check and clean the Cassette Micron Filter once a month to maintain
good performance. The filter can be cleaned by vacuuming with another
cleaner or brushing dust off into the trash. Recommended changing of
the Cassette Micron Filter is once every three months.
To change the Cassette Micron Filter:
1. Remove the filter frame by grasping the handle on the back of the filter
frame and pulling firmly. The filter frame will drop down staying connected
at the hinges on the bottom.
2. Remove old filter from filter frame and replace with a new filter.
3. Reconnect filter frame to cassette body by swinging filter frame up and
pushing against cassette body until it snaps into place.
9
b
a
3
How to Maintain
The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the
cyclonic cassette, belt, and brush roll often.
How To Empty Cyclonic Cassette
NOTE: Turn off the switch and unplug the electrical cord before emptying cyclonic cassette. Never operate the
vacuum cleaner without the cyclonic cassette or the filter.
Emptying the Cyclonic Cassette:
It is clearly visible when the dust compartment is full and needs emptying. Lift
screen as shown (3) to completely empty cyclonic cassette. It is possible to clean
out the cyclonic cassette by using another vacuum.
CAUTION: The cyclonic cassette can be washed in warm water, if desired, but
strong detergents should not be used. Dry thoroughly before using
again.
NOTE: The compartment with the screen (a) will fill much faster with larger
dirt particles than the compartment with the cone (b). This is normal,
empty the cyclonic cassette when the side with the screen is full, do
not wait for the side with the cone to fill completely.
An over full cyclonic cassette will allow dirt to pass directly into the
micron filter. Empty cyclonic cassette often.
2
1
|
1
2
1. Filter Frame
2. Filter
3. Cassette Body
Use GENUINE EUREKA replacement
filter, 28115A. Look for the GENUINE
EUREKA product symbol.
|
|
|
|
|
3