Filter
Top Products
16
Motor will not start. Electric Plug Push plug securely into outlet.
Try another outlet.
Check circuit breaker.
Motor suddenly stops. Thermal Cut Off Refer to page 7.
Does not clean the carpet Filters Clean or replace the filter(s). Hint: If picking up fine
or floor. dust, the cyclonic cassette may not look full but a fine
substance tends to reduce suction when it blocks the
airflow through the filter(s).
Cyclonic Cassette Be sure hose adapter inserts into cyclonic cassette.
Be sure the cyclonic cassette is properly seated into
the cassette body. See page 6.
Empty cyclonic cassette. Note: There are two
chambers in the cyclonic cassette. The chamber with
the screen will fill much faster than the chamber with
the cone. This is normal. When the chamber with the
screen is full, empty cyclonic cassette. Do not wait till
the chamber with the cone is full. See page 9.
Belt Replace a cut, loose or out of shape belt.
Belt Cover Snap the belt cover inside the hood if it comes loose.
Brush Roll Clean hair and thread from bristles and end cap area.
Replace brush roll if bristles are worn.
Hose Remove any clogs from the hose that restrict the
airflow. Check short hose in the base and long hose.
Refer to page 12 & 13.
No suction at the end of Hose Adapter Hose adapter has to seat inside the cyclonic cassette.
the hose. Filter(s) Clean or replace the filter(s). Hint: If picking up fine
dust, the cyclonic cassette may not look full, but a fine
substance tends to reduce suction when it blocks the
airflow through the cyclonic cassette and filter(s).
Hose Remove any clogs from the hose that restrict the
airflow. Check short hose in the base and long hose.
Refer to page 12 & 13.
Headlight not working. Light Bulb Replace light bulb. Refer to page 15.
Noise from the brush roll Brush Roll Remove hood and clean debris or items from the
area. brush roll area.
Belt Replace a cut, loose or out of shape belt.
Cleaner is hard to push. Cleaner Height Put handle in operating position. Tilt the cleaner back
Setting to raise the front wheels off floor. Then turn the knob
to a higher setting.
Belt Replace a cut, loose or out of shape belt.
Cleaner height knob will Cleaner Height Hint: Put handle in operating position. Tilt the
not turn. Setting cleaner back to raise the front wheels off floor.
Then turn the knob.
PROBLEM SOLVING
NOTE: Turn off the switch and unplug the electrical cord before servicing.
PROBLEM CAUSE SOLUTION
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3