HOW TO ASSEMBLE
Assemble completely before using.
1. Attaching or Removing Floor Nozzle.
Align the lock button on the floor nozzle neck with the
hole in the receiving tube on the main body. Push the lock
button and slide the floor nozzle into the main body until
it clicks into place. Push the lock button in and pull on the
floor nozzle to remove it from the main body.
2. Attach Handle Grip.
Align the lock button on the handle tube with the hole in
the handle grip. Push the lock button and slide the handle
into place
3. Attach handle tube to the cleaner.
Insert the end of the handle tube with the guide tabs into
the cleaner. Push the handle release button to get the
handle tube fully inserted. The handle is properly inserted
when you hear a click.
4. Attach Hose and Hose Holder.
Snap the hose holder into place on the top of the unit. Insert
the hose end with the guide tabs into the hose coupling
and twist counter clockwise to lock.
3
IDENTIFY PARTS
1
Off / Suction /
Brushroll Switch
Handle Grip
Handle Tube
Dust Cup
Cord Retainer
Cord Hooks
Receiving Tube
5. Store Cord (using cord hooks).
Pull the electrical cord down around the lower cord hook,
then wrap cord around upper and lower cord hooks.
Fasten plug to electrical cord to prevent unwinding.
6. Store Unit.
Push the telescoping handle release button to lower the
handle into its compact storage position. The handle is
locked down when a click is heard.
Dust Cup
Release Button
Telescoping
Handle Release
Lock Button
Connector Pins
Brushroll
Reset Button
3
2
Clean Out Port
Brushroll
Clean Out
Port (Open)
Hose
Coupling
Hose Holder
4
6
5
Dusting
Brush
Hose
Actuator
Valve