Eureka 2590 Series Carpet Cleaner User Manual


 
C. Emptying the Recovery Tank
CAUTION: Turn off the power switch and unplug the extractor to empty the recovery tank.
1) Pull straight up to remove the recovery tank from the unit.
2) Remove the automatic shut-off (see illustration) and empty contents
into a suitable water drain.
3) Rinse out the waste water recovery tank thoroughly.
4) Remove and clean the float and filter by rinsing it with water after each
use. Place the same float and filter back into the recovery tank.
5) Gently push the tank all the way into unit until secure.
6) Resume cleaning or store.
6
STEP
2
USE
A. Carpet Cleaning
1) Adjust shampoo control, from
MAX = for heavy traffic areas to
RINSE = clear water only.
2) Plug in cord.
3) Lift handle to operating position.
Shampoo
Control
Handle
Release Pedal
4) Push power switch to II position for agitation of brush.
5) Push the handle foot release and recline handle to use position.
Push shampoo/rinse button and hold to apply solution and
move the unit forward and then backward at a moderate pace
two times. As the nozzle moves over the carpet, the cleaning
solution is sprayed onto the carpet. At the same time the nozzle
picks up the dirty water and places it in the recovery tank. It is
important to move the unit in a steady motion.
6) Release the button to stop the solution flow. Avoid over-
soaking.
7) Move the extractor over the carpet several more times without
pushing the shampoo/rinse button. This removes excess water
and helps the carpet dry faster.
8) Repeat steps 5, 6, and 7 on heavily soiled areas.
Power Switch
II Brushes
I Suction Only
0 OFF
Shampoo/
Rinse
Button
Carrying
Handle
B. Transporting the Extractor
When moving the unit from one location to another, always make
sure the recovery and clean water solution tanks are completely
empty. Then tilt the unit slightly backward and roll on rear wheels
or use the carrying handle for transporting up and down stairs.
(See page 4)
D. Automatic Shut-Off
The automatic suction shut-off functions when the waste water recovery tank is
full of liquid. This can be detected by a noticeable difference in the motor sound.
Immediately turn off the unit when this happens and empty the recovery tank.
Automatic
Suction
Shut-Off
Recovery
Tank
Filter