Filter
Top Products
ASSEMBLY, FILLING & OPERATION
ASSEMBLY
1) Unpack humidifier from carton.
2) Remove all packaging material, wicks, etc. from cabinet.
3) The wicks are located by four pairs of ribs in the bottom of the
cabinet. Locate the two wicks. REMOVE THE PLASTIC WRAP
AROUND WICKS. Insert them by dropping each one down into
the locating ribs (see illustration).
4) After inserting the wicks, place the transition molding on top of
them, flange side up. The notch along one side of the transition
goes to the back of the cabinet.
5) Place the chassis unit onto cabinet.
FILLING
6) Before replacing the chassis, fill the reservoir with water. DO NOT POUR WATER
OVER THE ELECTRICAL CHASSIS. Fill the cabinet only through the opening between
the left wick and the cabinet sidewall. If water spills on the chassis, it must be allowed to
dry completely before energizing the humidifier. If you have only softened water
available in your home, you can use it, but you will notice a build up of minerals on the
evaporative wicks much sooner. Reservoir capacity is 3.0 gallons. DO NOT OVERFILL.
7) We recommend using Essick Air Bacteriostat Treatment, whenever you refill the
humidifier reservoir to eliminate bacterial growth. Add bacteriostat according to the
instructions on the bottle.
OPERATION
8) Replace the chassis.
9) Plug cordset into wall.
10) The digital control allows you to use the low setting for the quietest operation or a high
setting for maximum output.
11) For initial operation, push the speed button once for the sleep setting and continuously
press the button to increase desired speed. TO STOP the unit, press the speed button
for two seconds, or keep pressing button until display reads OFF.
12) To take advantage of the digital humidistat, press the speed button to any setting other
than OFF. Then adjust the set humidity by using the up and down buttons. Humidity will
increase in increments of 10%. When the room humidity level rises above the set
humidity, the humidifier will stop. When the humidity level drops below the set humidity,
the humidifier will turn on automatically.
13) Turn humidifier ON, the humidity is regulated by using the HI/LO speed switch.
Transition
Molding