Filter
Top Products
16
5. Attaching the attachment plate to the projector
1) Place the projector upside down.
2) Attach the attachment plate to the projector using the hexagonal wrench (M4) and five M4 x 12 mm bolts with washers/
spring washers.
6. Attaching the projector to the adjustment unit
1) Slide the attachment plate onto the adjustment unit as shown below.
2) Secure the adjustment unit temporarily at the points marked using two M4 x 12 mm bolts as shown below.
q
Tighten the screws firmly.
M4 x 12 mm hexagon socket head cap
bolts (x5)
with washers/spring washers
Attachment plate
Projector lens side
If you apply adhesives to prevent the screws from loosening, or if you use lubricants or oils on the wall mount,
the housing may crack and cause the projector to fall, resulting in personal injury or property damage. Do not
use adhesives, lubricants, or oils to install or adjust the mount.
Warning
M4 x 12 mm hexagon
socket head cap bolt
with washers
Adjustment unit
Attachment plate
Mark
M4 x 12 mm hexagon
socket head cap bolt
without washers