Filter
Top Products
7
Figure 5: Screws to take out to remove
stove from pallet.
Installation
REMOVING PELLET STOVE FROM PALLET AND INSTALLING HEARTH PAD:
Figure 4: Screws at the back of the
cabinet side.
Figure 3: Screw behind ash box.
Tool Required:
● T-20 screwdriver
●
5
/16” socket or flat head
screwdriver
Installation:
1. Slide a hearth pad tab
through each of the three
(3) slots on the hearth pad
so the slotted end is up and
secure in place with a T-20
screw through the pad into the tab (refer to Figure 2).
2. Open the ash pan cover from the right then lift the cover up and
out to unhook the hinges at the left.
3. Remove the cab sides.
a) Ensure the screws behind the ash box (Figure 3) and the three
(3) on each side at the back (Figure 4) are loosened.
Figure 2: Installing tabs into hearth
pad.
Figure 6: Mini Bern Hearth Pad in Place.
b) Remove knob and collar from slider rod.
c) Pull the cab sides straight out.
4. Using a
5
/16” socket or flat head screwdriver, remove the three
(3) wood screws that are holding the bottom of the stove to the
pallet. There is one (1) screw behind each side panel and one (1)
at the back behind the back grill (refer to Figure 5).
5. Loosen the three (3) T-20 screws from the base of the unit (see
Figure 6).
6. Either lift the unit up and
place it into the hearth pad
or carefully place the unit
on its back; it can rest on
the pallet it was shipped
on (allow the pipes to t
through an opening in the
pallet).
7. Align the three (3) tabs on
the hearth pad to the three
(3) screws on the unit (see
Figure 6), slide
together, and
tighten the T-20
screws.
8. Adjust the leveling
legs to level and
support stove.
9. Re-install the cab
sides and ash pan
cover.