Filter
Top Products
13
Secondary Installation
INSTALLATION OF LOG SET AND EMBERS:
CAUTION: Use only the type of ember
material supplied with this appliance.
Due to the irregular size of the ember
material there may be more than
required. The use of other foreign
materials on the burners may create
dangerous conditions.
If over time, through cleaning and
servicing, these embers require
replacement, contact the nearest
ENVIRO dealer for replacement
embers.
1. The embers can be place before
or after the logs are placed. A bag of
ceramic ber embers and rock wool
embers is provided gently remove the
ember material from the plastic bag.
Spread a layer loosely in a random
manner across the burner tray. Do not
allow any embers to rest against pilot
assembly. (See Figure 12 or 15 for
proper ember placement.)
DO NOT pack this ember material as
this could create an unsafe condition,
leave embers loose
2. Carefully remove logs from box.
Check to ensure there is no damage.
It is very important to install all logs
in their proper position to insure safe,
optimum operating conditions.
3. Place the log set into the rebox.
Locate each log by seating it down onto
the burner tray support pins. Follow
Figures 11 to 15 proper log placement.
Pins for Left Log
Pins for Rear Log
Figure 11: Step 1 of Log Placement.
Figure 12: Step 2 of Log Placement
Figure 13: Step 3 of Log Placement.
The placement of the logs is not arbitrary. If they are positioned incorrectly, the ames can be “pinched” and will
not burn correctly. The burner come with ve (5) locator pins, and the rear log has one (1) ledge, which make
alignment easier. Using the pictures provided, carefully set the logs in place.
NOTE: The logs are fragile and should be handled gently.