Filter
Top Products
12
EXHAUST PASSAGES (season)
Removal of the firebox backing for bi-
annual cleaning (refer to Figure 8):
• Open the door by lifting the handle, remove
the burn pot and burn pot liner.
• Lubricate all screws with penetrating oil.
• Remove the four (4) screws that hold the
brick liner retainers in place. Remove side
brick liners by sliding them forward then
out.
• Pull the center panel out.
• Vacuum and clean thoroughly.
Installation of firebox backing:
• Insert center panel with backing.
• Place the two (2) side panels back into the
firebox and reinstall the two (2) retainers
using two (2) screws on each side.
• Replace the burn pot and burn pot liner
• Close the glass door and secure.
Routine Cleaning and Maintenance
Figure 8: Firebox Components Removal.
POST SEASON CLEAN-UP
Once you are finished using the pellet appliance for the season, unplug the stove for added electrical
protection. It is very important that the stove be cleaned and serviced as stated above.
CLEANING PLATED SURFACES
Painted surfaces should be wiped with a damp cloth periodically.
It is important to note that fingerprints and other marks can leave a permanent stain on plated finishes.
To avoid this, give the surface a quick wipe with denatured alcohol on a soft cloth BEFORE lighting the
fireplace. Never clean surfaces when they are hot. Do not use other cleaners or abrasives as they may
leave a residue or scratches, which can become permanently etched into the surface.
FIREBOX PANEL
The paint on the steel firebox panels may peel. This is due to extreme conditions applied to the paint and
is in no way covered by warranty.
REPLACING DOOR GLASS
It is recommended that your ENVIRO dealer replace the glass if broken.
The door glass is made of high temperature PYRO CERAMIC 5 mm thick. The center panel is 15.4” x 9.0”
(39.0 cm x 22.9 cm) and side panels are 2.6 x 9.0 inches (6.7 cm x 22.9 cm). They must be replaced with
(Part # EF-062). Substitute materials will not be permitted.