Filter
Top Products
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE
TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.
24
Control Board
The Control Board (Part # CPM-CB07) is a digital read-out board. This board offers a wide
variety of settings to operate the unit. This part can be removed from the unit by loosening the two
outside screws and pulling the board back to the inside of the stove. The rear access panel should
be removed prior to removing the control board. A 6-amp “quick-blow” fuse is used on this Control
Board. See safety notes below diagram.
NOTE: The bottom three control buttons are preset at the factory and should not require any
changes. See “Operating Instructions” and “Daily Operation” section of the manual for
instructions on other Control Board settings.
CAUTION: Moving Parts May Cause Injury.
Do NOT Operate with Panel(s) Off.
DANGER: Parts May Be Hot. Risk of Electric Shock.
Disconnect Power Before Servicing Unit.
Recommended Heat Ranges:
Low Burn: Heat Range setting: 1 Room Air Blower setting: 1
Medium Low: Heat Range setting: 2 – 3 Room Air Blower setting: *
Medium High: Heat Range setting: 4 – 8 Room Air Blower setting: *
High Burn: Heat Range setting: 9 Room Air Blower setting: 9
* NOTE: Blower Speed will automatically be adjusted to the desired Heat Range that you select.
NOTE: The bottom
3 buttons are pre-set at
the factory and do not
need adjustment.
Call Technical Support
at (800) 245-6489 if you
have questions or
p
roblems.
CAUTION:
Illustration 6
Control Board Diagram