Filter
Top Products
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description,
refer to exploded view illustration.
a. Fan motor assembly
b. One switch housing
c. Five fan blades
d. One ceiling cover
e. Five blade flanges
f. One remote control transmitter
g. One remote control receiver
h. One hanger ball/downrod assembly
i. One hanger bracket
j. One coupling cover
k. Three rod assemblies
l. One rod support assembly
m.One 18” downrod
n. One loose parts bag containing:
1. Sixteen 3/16-24 x 3/8” slotted washer
head blade screws
2. Sixteen plastic washers
3. Eleven 1/4-20 x 1/2” flange screws
4. Three wire connectors
5. Two threaded studs
6. Two knurled knobs
7. Two lockwashers
This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
One Phillips head screwdriver One stepladder
One 1/4” blade screwdriver One wire stripper
Three wire connectors (supplied)
MATERIALS
1. Wiring outlet box and box connectors must be of
type required by the local code. The minimum wire
would be a 3-conductor (2-wire with ground) of the
following size:
3
Installed Wire Length Wire Size A.W.G.
Up to 50 ft. 14
50-100 ft. 12
2. A 9-volt alkaline battery is required for operating
the remote control.
3. Four 40-watt (maximum) candelabra base lamps
are required for the uplights.
Unpacking Instructions
For your convenience, check-off boxes are provided next to each step. As each step is completed, place a
check mark in the box. This will insure that all steps have been completed and will be helpful in finding
your place should you be interrupted.
Before assembly your ceiling fan, refer to instructions
on proper method of wiring your fan (page 6). If you feel
you do not have enough wiring knowledge or experi-
ence, have your fan installed by a licensed electrician.
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Company. Substitution of parts or acces-
sories not designated for use with this product by
Emerson Company could result in personal injury or
property damage.
8. One clevis pin
9. One hairpin clip
10. One 5/64” hex wrench
NOTE: Place the parts from the loose parts bags
in a small container to keep them from being lost.
If any parts are missing, contact your local retail-
er or catalog outlet for replacement before
proceeding.
2. Remove the fan motor assembly from the
protective plastic bag and place it into the lower
foam pad with the top of the fan motor assembly
facing up.
The lower foam pad serves as a holder for the fan
during assembly.
BLADE
FLANGES
ROD SUPPORT
ASSEMBLY
HANGER BALL/
DOWNROD
ASSEMBLY
COUPLING
COVER
FAN MOTOR
ASSEMBLY
SWITCH
HOUSING
REMOTE
CONTROL
RECEIVER
REMOTE
CONTROL
TRANSMITTER
LOOSE
PARTS
BAG
HANGER
BRACKET
CEILING
COVER
18" DOWNROD
ROD ASSEMBLY (3)
FAN
BLADES
WARNING
!
WARNING
!
WARNING
!