Filter
Top Products
Unpacking Instructions
1. Open carton containing fan. Remove top half of
styrofoam unit. Remove parts and check to see
that you have received the following parts:
NOTE: If you are uncertain of part description,
refer to exploded view illustration.
a. Fan motor assembly
b. One ceiling mounting plate
c. One fan housing trim ring
d. One fan housing cover
e. Five fan blades
f. Five blade flanges
g. One switch housing assembly
h. One 4-speed slide wall control with hardware
i. One loose parts bag containing:
1. Sixteen 10-24 x 5/16" washer head blade
screws
2. One 1/4-20 x 9/16" captive flange screw
with lockwasher (spare)
3. One 8-32 x 5/16" switch cup screw (spare)
4. Four wire connectors
5. One 10-24 x 3/8" Pan head screw (spare)
6. One 10-24 x 3/8" Pan head screw with
lockwasher (spare)
7. One balancing kit
This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
One Phillips head screwdriver One stepladder
One 1/4” blade screwdriver One wire stripper
MATERIALS
Wiring outlet box and box connectors must be of
type required by the local code. The minimum wire
would be a 3-conductor (2-wire with ground) of the
following size:
6
Installed Wire Length Wire Size A.W.G.
Up to 50 ft. 14
50-100 ft. 12
Before assembly your ceiling fan, refer to section
on proper method of wiring your fan (page 8).
If you feel you do not have enough wiring
knowledge or experience, have your fan installed
by a licensed electrician.
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson Electric Co. could result in personal
injury or property damage.
4
0
3
2
1
d.
a.
b.
c.
f.
i.
h.
e.
g.
WARNING
!
WARNING
!
WARNING
!
NOTE: Place the parts from the loose parts bags
in a small container to keep them from being lost.
If any parts are missing, contact your local
retailer or catalog outlet for replacement before
proceeding.
2. Remove the fan assembly from the protective
plastic bag. Place the fan assembly into the upper
foam pad with the lead wires up.